2012 Ford Flex Sel on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

Ford Mustang Shelby GT500 has a bit of a dyno issue

We're of the mind that each and every dyno should come with Murphy's Law painted in big, visible letters down the side. For every ten successful dyno runs out there, it seems there's one where events to horribly wrong. Take, for example, the video below. The clip shows what happens when a Ford Shelby GT500 and a mobile dyno have a bit of a disagreement at the Performance Expo 24 in Sherbrooke, Quebec. We won't spoil the results for you, but we will say there's some substantial carnage involved.
It's unclear just how much damage ensues from the dust up or whether anyone was harmed in the incident, but from the looks of things, everyone made it out without serious injury. If only we could say the same for the machines involved. Check out the video below.

Defying Trump, major automakers finalize California emissions deal

WASHINGTON — The California Air Resources Board (CARB) and major automakers on Monday confirmed they had finalized binding agreements to cut vehicle emissions in the state, defying the Trump administration's push for weaker curbs on tailpipe pollution. The agreements with carmakers Ford Motor Co, Volkswagen AG, Honda Motor Co and BMW AG were first announced in July 2019 as voluntary measures prompting anger from U.S. President Donald Trump. A month later, the Justice Department opened an antitrust probe into the agreements. The government ended the investigation without action. The Trump administration in March finalized a rollback of U.S. vehicle emissions standards to require 1.5% annual increases in efficiency through 2026. That is far weaker than the 5% annual increases in the discarded rules adopted under President Barack Obama. The 50-page California agreements, which extend through 2026, are less onerous than the standards finalized by the Obama administration but tougher than the Trump administration standards. The automakers have also agreed to electric vehicle commitments. Volvo Cars, owned by China's Geely Holdings, said in March it planned to join the automakers agreeing to the California requirements. It has also finalized its agreement. The settlement agreements say California and automakers agreed to resolve "potential legal disputes concerning the authority of CARB" and other states that have adopted California's standards. In May, a group of 23 U.S. states led by California and some major cities, challenged the Trump vehicle emissions rule. Other major automakers like General Motors Co, Fiat Chrysler Automobiles NV and Toyota Motor Corp did not join the California agreement. Those companies also sided with the Trump administration in a separate lawsuit over whether the federal government can strip California of the right to set zero emission vehicle requirements. Ford said the "final agreement will reduce emissions in our vehicles at a more stringent rate, support and incentivize the production of electrified products, and create regulatory certainty." BMW said "by setting these long-term, predictable, and achievable standards, we have the regulatory certainty that is necessary for long-term planning that will not only reduce greenhouse gas emissions but ultimately benefit consumers as well."