1964 Ford Fairlane 500, 260 V8, Auto, New Paint, Rust Free, Runs Excellent on 2040-cars

Auto blog

Mustang parts under the new Lincoln Aviator mean good things for Ford

NEW YORK — As we mentioned last night, underneath the new Lincoln Aviator "concept" there appears to be an independent rear suspension lifted right from the Ford Mustang parts bin. And while it's pretty cool on its face that Mustang rear-drive platform bits are being reused in the broader Ford universe, what this means for the next Explorer could be really cool. A quick caveat: The Aviator here in New York is very close to the production version, but it's not technically a production car. It looks hand-built, with temporary exhaust and some show-car touches. The suspension underneath looks exactly like a Mustang's, but the actual production Aviator will almost certainly use beefier components with the same basic design and geometry, since the Aviator will be much heavier than the smaller Mustang. That being said, we're fairly confident that even at this early stage, the Mustang-derived suspension seen in New York is a preview of what'll be under the production Aviator. Furthermore, Ford won't say it, but based on what we're seeing on Aviator, it's a safe bet that Ford will utilize the Aviator platform for the next Explorer. That would enable the economies of scale necessary to produce a brand new rear-drive-based SUV platform in the first place. It also means that the Explorer should be available without AWD — and given the stable of powerful EcoBoost engines, and the competent 10-speed automatic in the parts bin, a rear-drive Explorer has a shot at being a decent driver. Aviator wouldn't go rear-drive-based if driving dynamics weren't important; Explorer should inherit these priorities. More evidence: The Explorer spy shots we saw back in February sure share the Aviator's general proportions. Even back then, before Aviator was revealed, we were hypothesizing that an EcoBoost 3.5-liter-powered version could boast as much as 400 horsepower, if the Expedition's tune were adopted. Suddenly, the Explorer seems very interesting. So, an EcoBoost, rear-drive Explorer sure sounds like something Ford Performance would be interested in, right? We knew an Explorer ST is coming, but with 365-400 horsepower potential and a chassis designed with dynamics in mind, it doesn't seem like as much of a stretch as the Edge ST. And a performance-oriented AWD system is a possibility, too. That's an area where Ford has been gathering experience at a rapid pace. What do we not expect from a new Explorer? A V8.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford to add more than 2,000 jobs in Kansas City

Continued high demand for the Ford F-150, along with the addition of the all-new Transit series of commercial vehicles, has led Ford to announce that it will add over 2,000 jobs at its Kansas City Assembly Plant. At the time of the announcement, the plant boasts 2,450 hourly employees working on two shifts. All told, Ford will invest $1.1 billion in the Kansas City plant to expand truck production and begin producing the Transit series.
According to the automaker, fullsize truck sales are up 19 percent through April of 2013, leading to an additional 900 workers and a third shift of production for the F-150. Production of the Transit series will begin in the fourth quarter of this year, requiring an additional 1,100 workers. In addition, Ford estimates that a total of 18,000 jobs will be created by suppliers to its Kansas City plant to support the additional vehicle production.
Want to know more? Scroll down for the complete press release.