2004 Ford F350 4wd Service Truck With Fuel Transfer on 2040-cars

Auto blog

Ford cleans up painting process with cameras

Knowing how the bacon gets made rarely entices us and, in the same vein, the same usually goes for knowing about how new cars get painted. But in both instances, however, quality - or a lack thereof - is instantly obvious. In terms of the latter, Ford is showing off its new paint quality process with 3D Dirt Detection Technology to find imperfections in vehicle paint more easily and more quickly.
This process - being performed on the F-150 SVT Raptor above - uses 16 computer-controlled cameras to create a three-dimensional model (inset) of the vehicle to detect flaws in the paint including dirt particles, which can then be buffed out manually. Ford says this new technology cuts down on time spent looking for paint flaws and gives workers more time to correct those that are discovered.
Currently, Ford only uses its 3D Dirt Detection Technology system at three factories (the Dearborn, MI facility, along with those in Louisville, Kentucky and Valencia, Spain), but it will soon spread to five more plants in North America. Ford has released a video and press release for this innovative and unexpectedly interesting process, both of which are posted below.

How Ford hid the 2015 Mustang from spy photographers

Now that we've finally seen the 2015 Ford Mustang, it's fun to go back and look at the spy shots we spent months pouring over, trying to dissect what was under all the camouflage. For the most part, Ford did a good job of concealing the car from spy photographers, and it released a video showing how much work went into doing so.
As crude as the Mustang's camo looked, all of the hard plastic, foam, vinyl and ratchet straps were actually created and put in place by a specific design team. The whole idea was to hide the car's identity, but it certainly ended up acting as a magnet for attention, too. According to Ford's press release, it took less than an hour for spy shots to appear online after the car was taken on public roads for the very first time - this is likely in reference to our first official spy shots of the Mustang from June, shown in the gallery below.
Scroll down for a press release and video, which shows footage of the 2015 Ford Mustang testing with minimal camouflage. This is probably the same track session where we got our first look at the Mustang's face back in August.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.