1995 Ford F350 Crew Cab Monster Show Advertising Truck Rockwell 2.5 Ton on 2040-cars

Auto blog

Toyota fears supplier pressure in Australia with GM pull out

With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.

2016 Ford Focus RS shows up in Geneva, still bound for America [w/video]

Representing the super-hot hatchback movement at the 2015 Geneva Motor Show, we have the 2015 Ford Focus RS, the third-generation to wear the performance-focused designation. Bound for America for the first time, it's fair to say we're darn excited for the Focus RS and its 2.3-liter, turbocharged four-cylinder. With at least 315 horsepower under the hood and the long-awaited inclusion of an all-wheel-drive system, there's little arguing that the RS will be seriously quick off the line. It should be darn good through the bends, too. The all-wheel-drive system packs a Dynamic Torque Vectoring Control system that sends up to 70 percent of the power to the rear axle. On top of the AWD's torque vectoring ability, the Focus RS adds a brake-based torque vectoring system, which transfers power laterally, as needed. Michelin Pilot Sport Cup 2 tires should only help keep the RS glued to the tarmac. A three-pedal setup is the sole transmission option, which should delight purists. According to Ford, both the clutch and the trans itself have been bolstered to handle the 2.3-liter's power. Ford also comprehensively upgraded the looks of the Focus RS relative to the lesser Focus ST. Its enormous rear wing and the back bumper's rear diffuser complement the car's menacing face. The ST's center-exit exhaust has been ditched for a meaty set of pipes, while the car on display in Geneva shows off a different set of alloys than what we saw during the car's original debut. Check out our full gallery of live photos of this hot Ford, available up top. And be sure to check out our Short Cut of the new hot hatch by scrolling down. All-New Ford Focus RS; High-Performance Hatch with Innovative All-Wheel Drive Set for U.S. Debut - Third-generation Ford Focus RS will be available in major markets around the world and for the first time in the United States; Focus RS follows the reveal last month of the new Ford GT supercar – a new era of Ford performance that will deliver 12 new vehicles by 2020 - All-new Ford Performance All-Wheel Drive with Dynamic Torque Vectoring Control paired with a powerful 2.3-liter EcoBoost® four-cylinder engine will provide impressive performance - Aggressive, functional design inside and out makes Focus RS the most powerful production Focus ever, with highly capable performance on both road and track - Professional rally driver and star of Gymkhana films Ken Block teamed with Ford as a consultant on development of Focus RS Cologne, Germany, Feb.

2015 F-150 launch to curb Ford profits?

Ford is making a big bet on aluminum with its new 2015 F-150, and it's possible that the decision will hurt the company financially, at least in the short term. After earning a record $8.6 billion in 2013, the Blue Oval does not expect to set another record in 2014. According to Automotive News, that's "largely attributable to F Series," says Bob Shanks, Ford's Chief Financial Officer.
To retool for the new F-150, Ford will idle its Dearborn Truck Plant in Michigan for 11 weeks and the Ford Kansas City Assembly Plant in Missouri for 2 weeks. "3 of the 13 overall weeks occur during what normally is our summer shutdown timeframe," said Mike Levine, Ford Trucks Communication Manager, in an email to Autoblog. The extra 10 weeks will be preparing for the more aluminum-intensive construction for the trucks and will mean over 2 months of no F-150s being made. For comparison's sake, Chrysler boss Sergio Marchionne just confirmed that the 200 plant in Sterling Heights, MI will be down for 30 days to retool for the new model, but obviously there are many more F-150 production variables than for the midsize sedan.
Levine notes that Ford is already running three shifts at both plants, and says the automaker has plans to ensure that there is adequate supply of the full-size pickups during the retooling process. The company does not want to suffer a shortage of the vehicle that accounted for 31-percent of its 2013 US sales and an even bigger percentage of its profits.