2013 Ford F-250 Super Duty Lariat Crew Cab Pickup 4-door 6.7l on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Feds Probe Power Steering In 938,000 Ford Midsize Cars

U.S. safety regulators are investigating complaints that the power-assisted steering can suddenly fail on three Ford midsize car models. The probe covers 938,000 Ford Fusion and Lincoln MKZ cars from the 2010 through 2012 model years, as well as the 2010 and 2011 Mercury Milan. The National Highway Traffic Safety Administration says it has received 508 complaints alleging that the cars lost power-assisted steering, causing increased steering effort. Four complaints say the problem caused crashes, but no injuries were reported. The agency says in documents posted Monday on its website that in many cases, a warning message appeared as the failure happened. Restarting the car corrected the problem in some cases, but the problem returned in others. The agency says it will check the scope and frequency of a problem. It could seek a recall. Ford says it's cooperating with the probe. Shares of Ford Motor Co. rose 6 cents to $14.65 in morning trading Monday. Its shares are down 14 percent over the past year. Related Gallery Our Favorite Hot And Sporty Cars For 2015 Recalls Ford Lincoln NHTSA Ford Motor Company power steering mercury milan investigation

Ford cleans up painting process with cameras

Knowing how the bacon gets made rarely entices us and, in the same vein, the same usually goes for knowing about how new cars get painted. But in both instances, however, quality - or a lack thereof - is instantly obvious. In terms of the latter, Ford is showing off its new paint quality process with 3D Dirt Detection Technology to find imperfections in vehicle paint more easily and more quickly.
This process - being performed on the F-150 SVT Raptor above - uses 16 computer-controlled cameras to create a three-dimensional model (inset) of the vehicle to detect flaws in the paint including dirt particles, which can then be buffed out manually. Ford says this new technology cuts down on time spent looking for paint flaws and gives workers more time to correct those that are discovered.
Currently, Ford only uses its 3D Dirt Detection Technology system at three factories (the Dearborn, MI facility, along with those in Louisville, Kentucky and Valencia, Spain), but it will soon spread to five more plants in North America. Ford has released a video and press release for this innovative and unexpectedly interesting process, both of which are posted below.