2012 Ford Super Duty F-250 Pickup King Ranch on 2040-cars

Auto blog

Ford recalling 2015 Mustang for fuel line leak, 20K Transit Connects for plastic panel

Ford is recalling 738 examples of the 2015 2015 Mustang with the 2.3-liter EcoBoost engine – 712 in the US, 16 in Canada. A fuel pressure sensor might have been installed incorrectly on the affected cars, and that could result in a fuel leak. At the time of writing the company hasn't heard any reports of any incidents related to the issue, and parties with affected vehicles can take them to the dealer to have the fuel tube assembly replaced free of charge. The 2014 Transit Connect Cargo Van is also the subject of a safety recall, due to a possible problem with adhesive used on the exterior plastic panel on the sliding doors. There are 19,825 units covered by that recall, which dealers will also repair free of charge. You can find more information on both bulletins in the press releases below. Ford Issues Safety Recall for Certain 2015 Mustang Vehicles in North America for Fuel Pressure Sensor Issue Dec 4, 2014 | DEARBORN, Mich. - Ford is issuing a safety recall for approximately 730 2015 Ford Mustang vehicles in North America (actual 728) for a potential fuel line leak. A fuel pressure sensor, which is part of the fuel supply tube assembly, may have been installed incorrectly, potentially resulting in a pressurized fuel leak. A fuel leak in the presence of an ignition source may result in a fire. Ford is not aware of any fires, accidents or injuries related to this condition. Affected vehicles include certain 2015 Ford Mustangs equipped with 2.3-liter engines built at Flat Rock Assembly Plant, Sept. 25, 2014 to Oct. 9, 2014. Ford is aware of 712 vehicles in the United States and federalized territories and 16 in Canada. These totals are as of Dec. 3, 2014. Dealers will replace the fuel supply tube assembly at no cost to the customer. *** Ford Issues Safety Recall for Certain 2014 Transit Connect Cargo Van Vehicles in North America for Issue with the Plastic Panel on the Sliding Doors Dec 4, 2014 | DEARBORN, Mich. - Ford is issuing a safety recall for approximately 20,000 2014 Transit Connect cargo van vehicles in North America (actual 19,825) for an issue with adhesion of an exterior plastic panel to the sliding doors. This issue may result in noise, a water leak, a loose panel, or separation of the plastic panel from the vehicle while driving, potentially increasing the risk of an accident or injury. Ford is not aware of any accidents or injuries related to this condition.

Ford Mustang Mach-E fails Sweden's moose test

The infamous moose test has claimed another casualty. This time it's the Ford Mustang Mach-E AWD Long Range, which was tested in an electric four-way alongside the Tesla Model Y, Hyundai Ioniq 5 and Skoda Enyaq iV (an electric utility vehicle closely related to the Volkswagen ID.4 that is sold in the United States). According to the Swedish testers at Teknikens Varld, Ford's electric car not only failed to hit the speed necessary for a passing grade, it didn't perform well at slower speeds, either. To pass the outlet's moose test, a car has to complete a rapid left-right-straight S-shaped pattern marked by cones at a speed of at least 72 km/h (44.7 miles per hour). The test is designed to mimic the type of avoidance maneuver a driver would have to take in order to avoid hitting something that wandered into the road, which in Sweden may be a moose but could just as easily be a deer or some other member of the animal kingdom elsewhere in the world, or possibly a child or car backing into the motorway. Not only is the maneuver very aggressive, it's also performed with weights belted into each seat and more weight added to the cargo area to hit the vehicle's maximum allowable carrying capacity. The Mustang Mach-E only managed to complete the moose test at 68 km/h (42.3 mph), well below the passing-grade threshold. Even at much lower speeds, Teknikens Varld says the Mach-E (which boasts the highest carrying capacity and was therefore loaded with more weight than the rest of the vehicles tested in this quartet) is "too soft in the chassis" and suffers from "too slow steering." Proving that it is indeed possible to pass the test, the Hyundai and Skoda completed the maneuver at the 44.7-mph figure required for a passing grade and the Tesla did it at 46.6 mph, albeit with less weight in the cargo area. It's not clear whether other versions of the Mustang Mach-E would pass the test. It's also unknown if Ford will make any changes to its chassis tuning or electronic stability control software, as some other automakers have done after a poor performance from Teknikens Varld, to improve its performance in the moose test. Related video:

Nuclear-powered concept cars from the Atomic Age

In the 1950s and early 60s, the dawn of nuclear power was supposed to lead to a limitless consumer culture, a world of flying cars and autonomous kitchens all powered by clean energy. In Europe, it offered the then-limping continent a cheap, inexhaustible supply of power after years of rationing and infrastructure damage brought on by two World Wars.
The development of nuclear-powered submarines and ships during the 1940s and 50s led car designers to begin conceptualizing atomic vehicles. Fueled by a consistent reaction, these cars would theoretically produce no harmful byproducts and rarely need to refuel. Combining these vehicles with the new interstate system presented amazing potential for American mobility.
But the fantasy soon faded. There were just too many problems with the realities of nuclear power. For starters, the powerplant would be too small to attain a reaction unless the car contained weapons-grade atomic materials. Doing so would mean every fender-bender could result in a minor nuclear holocaust. Additionally, many of the designers assumed a lightweight shielding material or even forcefields would eventually be invented (they still haven't) to protect passengers from harmful radiation. Analyses of the atomic car concept at the time determined that a 50-ton lead barrier would be necessary to prevent exposure.