Sharp F150 Regular Cab Stx Pwr Opts A/c Cd 4.2l V6 2wd Clean! on 2040-cars

Auto blog

Ford recalls 9,900 vehicles across two campaigns

Ford is recalling a total of 9,885 vehicles in two campaigns. The Basics: In one recall, Ford will recall 9,017 examples of the 2013 Escape with build dates from January 11, 2012, to April 1, 2013, and the 2013-2014 Focus ST produced between May 3, 2012, and October 14, 2013. The Problem: Splices in the engine wiring harness might not have enough compression, and this can cause the manifold absolute pressure sensor to send incorrect signals to the powertrain control module. This issue could cause the engine to stall. Injuries/Deaths: None reported. The Fix: Dealers will replace the current crimped splices with new splices, according to the National Highway Traffic Safety Administration. If You Own One: The repair campaign will begin on January 4, 2016. More Information: Ford recalled the 2013 Escape and Focus ST in August 2014 for the same problem, and this is an expansion of that campaign, according to company spokesperson John Cangany to Autoblog. The Basics: In the smaller of the two campaigns, Ford will recall 868 examples of the 2013 Explorer, Explorer Police Utility, Taurus, Taurus Police Interceptor, Flex, Lincoln MKS, and MKT. The Problem: The fuel delivery module can crack, which would cause a fuel leak. Injuries/Deaths: None reported. The Fix: Dealers will replace the fuel delivery module. If You Own One: Owners should receive notice soon because NHTSA's report says the recall begins in December. More Information: According to Cangany, this recall is an expansion of a campaign from 2013 for these vehicles. RECALL Subject : Engine Wiring Splices may cause Stall Report Receipt Date: DEC 02, 2015 NHTSA Campaign Number: 15V813000 Component(s): ELECTRICAL SYSTEM Potential Number of Units Affected: 9,017 All Products Associated with this Recall Vehicle Make Model Model Year(s) FORD ESCAPE 2013 FORD FOCUS 2013-2014 Details Manufacturer: Ford Motor Company SUMMARY: Ford Motor Company (Ford) is recalling certain model year 2013 Escape vehicles manufactured January 11, 2012, to April 1, 2013, and 2013-2014 Focus ST vehicles manufactured May 03, 2012, to October 14, 2013. Insufficient compression in the engine wiring harness splices to the Manifold Absolute Pressure (MAP) sensor may provide incorrect signals to the powertrain control module (PCM). CONSEQUENCE: The incorrect signals could cause the vehicle to hesitate or the engine to stall, increasing the risk of a crash.

Recharge Wrap-up: Ford 1.0L EcoBoost a hit in Europe; Build a tiny inverter, win $1 million

In Europe, Ford's 1.0-liter EcoBoost engine is the best-selling turbocharged gasoline engine. The three-cylinder motor powers 20 percent of new Fords sold in Europe. Earlier this year, it won its third International Engine of the Year award, and between January and June, it was sold in about 120,000 cars. So far this year, 38 percent of Fords sold in the Netherlands, 35 percent in Denmark and 32 percent in Switzerland have been powered by the 1.0-liter EcoBoost. The engine's turbocharger spins at 248,000 rpm, and provides 24 psi of pressure. The engine produces up to 138 horsepower, depending on the version. Read more in the press release below. When lithium-ion battery packs are retired from the road, remanufacturing, repurposing, and recycling are worthwhile options, according to a study by Mineta Transportation Institute. The study included a cost-benefit analysis of those three options, and found remanufacturing to be the best route. To get the most out of them, batteries should be tested and have their damaged cells replaced then put back to use. Repurposing is the second best option, using the remaining available charge for something besides cars. Recycling on its own isn't profitable, but it could make economic sense with "increased technological breakthroughs." Learn more at Recycling International or download the report here. A smaller inverter for EVs can win you $1 million. The Little Box Challenge is an open competition to build a power inverter with a density of at least 50 watts per cubic inch. Google and the Institute of Electrical and Electronics Engineers (IEEE) are offering the hefty prize to the team that builds the inverter with the highest power density within an enclosed volume of 40 cubic inches. Teams must register by September 30. Read more at Green Car Congress or learn more at the Little Box Challenge website.

Bacon-wrapped Ford Fiesta hams it up for International Bacon Day

This is a bacon-wrapped Ford Fiesta. It is a real thing, that a real, multi-billion-dollar company designed. And it isn't even April Fools' Day. Designed for International Bacon Day, which is also apparently a thing, the 2014 Fiesta is finished in Green Envy paint - we're told black paint, like the color of a skillet, made the car look camouflaged - and features 10 gigantic decals depicting strips of tender, cured bacon.
The design, which was approved by the CEO of Benton's Country Hams, Allan Benton, show off the depth of Ford's Custom Graphics program. Unbelievably, Ford will actually start offering bacon decals to everyday customers, including (and we can't believe we're writing this) dual bacon racing stripes which will no doubt have Carroll Shelby spinning and/or salivating in his grave, and a "side of bacon," which wraps a couple of strips over the rear wheels.
Benton, who Ford claims is the King of Bacon, had this to say: "This car just makes so much sense." The Fiesta's marketing manager, Liz Elser added, "It's just awesome to drive down the road in a piece of bacon."