Ford F-150 Xlt Lariat 4x4 Extended Cab Two Tone Leather on 2040-cars

Auto blog

2017-19 Ford Super Duty trucks recalled for tailgates that could open

Ford announced two separate recalls today, though neither has resulted in any known injuries. The first recall, which deals with a tailgate malfunction, affects 261,617 examples of 2017-2019 F-250, F-350, and F-450 Super Duty pickups. The second, which anticipates the possibility of a fuel leak, affects 3,893 units of 2020 Explorer and 2020 Lincoln Aviator SUVs with 3.0-liter engines. Ford says tailgates might accidentally open on some 2017-2019 Super Duty trucks because of a short circuit. If the pickups have an electric tailgate latch-release switch on the tailgate handle, water might get into the wiring. If the water hits the right spots, a short circuit could cause the switch to release the tailgate latch. In a worst-case scenario where the tailgate opens while driving, contents of the truck's bed could fall out and create a safety hazard. Dealerships will fix the problem by modifying the tailgate frame wiring harnesses with jumper pigtails and install a new tailgate handle release switch. Of the lot, 231,664 trucks are in the U.S., and 29,953 are in Canada. The Ford recall number is 19S48.  The second recall is much smaller, involving fewer than 4,000 vehicles. In certain 2020 Explorers and Aviators with 3.0-liter engines, Ford says, "The convolute protective sleeve on the liquid fuel line is not long enough, which may allow for potential hard contact with the convolute-protected vapor fuel line. Over time, with vibration and engine roll, hard contact between the two fuel lines could cause the convolute on the vapor fuel line to rub through the plastic liquid fuel line." If that happens, it could be a fire risk and hazardous for drivers and passengers. Only 35 of those SUVs are in Canada, and the rest are in the United States. Dealers will fix the problem by replacing the defective convolute with a full-length piece and tying it down with a strap. The recall reference number for the Aviators and Explorers is 19S49. The recall adds to what has otherwise been a rocky early production phase for the new Explorers and Aviators.

Why Edmunds took a sledgehammer to its 2015 Ford F-150

The discussion around repair bills for the aluminum-bodied 2015 Ford F-150 pickup continued from the beginning of last year to the end, and haven't abated; as an aside, some Tesla Model S owners have been shocked at disquieting repair estimates for minor damage to their aluminum wunder-sedans. Edmunds decided to inject some fact into the fray: it bought a $52,000 long-term 2015 F-150 and clouted it with an eight-pound sledgehammer. Twice. The rear of the bedside took the impacts since it couldn't be replaced, it would have to be repaired. To the pickup's credit, the only reason associate editor Travis Langness hit it twice was that the first sledgehammer blow didn't do as much damage as Edmunds wanted. After the second, the visible damage included the two direct impacts, a few creases, and a cracked taillight, so they drove the pickup to Santa Monica Ford to get an estimate, complete with a fictitious story about how the damage occurred and the mercy plea that Langness was paying for the repair out-of-pocket. In Part 2 Langness hits on some of the details with getting the truck fixed, such as the massively expensive taillight and the list of tools Ford recommends dealers have to work on aluminum. But he was promised he'd have his truck back in seven days, and Santa Monica Ford got it back to him in seven days. In Part 3 we get the bill. It's not small, but it's quite a bit less than it could have been if the service manager had charged Edmunds the official labor rate for aluminum. We're not going to spoil it here, so check out the videos above and below for the beginning and the end, and head over to Edmunds for the complete story about how it all happened and some riffing on the repair numbers. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Related Video:

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.