2014 Ford F150 Style on 2040-cars

Auto blog

NHTSA closes investigations into Ford Taurus, Hyundai Santa Fe

Ford and Hyundai are out from under the scrutinizing eyes of the National Highway Traffic Safety Administration after the government agency said it was closing investigations against both automakers over vehicle safety concerns.
Ford was being investigated for reported damaged speed control cables on Ford Taurus (shown above) and Mercury Sable models, both built between 2000 and 2003. Vehicles with the company's Duratec engines allegedly failed to allow owners to brake as expected. Owners lodged 100 complaints and were involved in five accidents, according to NHTSA records. The American automaker responded to the reports, and on June 21 of this year, said that it would inspect and repair all affected vehicles, regardless of the mileage.
Hyundai was under investigation for a reported loose fastener on the steering shaft of its 2011 Santa Fe (shown in the gallery below). After NHTSA launched its inquiry, the Korean automaker responded with its own investigation that yielded four affected vehicles. Following the inspection of 680 vehicles at its assembly plant, Hyundai said the issue was due to employee error and that no further defects have been found.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford Mondeo with 1.5-liter EcoBoost debuts in China

Does the car above, posing fancifully in white, look familiar? Well, it should. Although it wears Mondeo badges in the form you see above for the Chinese market - as it does in Europe - the car is basically the same thing sold in the US as the Ford Fusion. Of course, it's what's under that shapely skin that counts.
Ford has chosen the Shanghai Motor Show as the venue with which to unveil its 1.5-liter EcoBoost four-cylinder engine. We'd heard about the engine before, but now we have a few performance estimates to share: 133 kW of power (about 178 horsepower) and 240 Nm of torque (about 177 pound-feet).
Those numbers pretty much confirm previous rumors indicating about 177 in each category, and it's right on par with what Ford's own 1.6-liter EcoBoost produces. Ford is claiming best-in-class fuel economy as well, but no specific figures have yet been provided. In any case, we'll surely have all the data soon enough, as the 1.5-liter mill is destined for the US Fusion in 2014.