2014 Ford F150 on 2040-cars

Auto blog

NHTSA closes rollaway investigation into 1.56M Ford SUVs

It's taken four years of study, but the National Highway Traffic Safety Administration has finally closed the books on its investigation into rollaway accusations surrounding 1.56-million Ford SUV models.
The probe, which centered on the 2002-2005 Ford Explorer, 2002-2005 Mercury Mountaineer and 2003-2005 Lincoln Aviator, ends without the federal agency calling for a recall. According to The Detroit News, the investigation was closed due to a "low number of complaints" - NHTSA documented 180 such complaints that resulted in 14 crashes and six minor injuries, but the number of incidents have been slowing. The suspected defect rate for the trucks' automatic transmissions was found to be 4.4 per 100,000 units, and the brake-shift interlock mechanism failure rate was judged to be even lower at 3.4 per 100k.

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Ford shutters Genk assembly plant in Belgium

Ford has become the latest automaker to close one of its European assembly plants. The facility in question is located in the Belgian city of Genk and has been in operation since the early '60s when it started building the Taunus, Ford's first mass-produced, front-drive model. As part of the plan first announced over two years ago, the Genk Body & Assembly Plant is now closing its doors after half a century in the business and over fourteen million vehicles built. Although the plant itself employed some 5,000 workers, once you take into account the suppliers built up around the plant, the overall impact on employment in the area edges closer to 12,000. Genk Body & Assembly had until recently been tasked with producing the Mondeo sedan (which in its current iteration we know as the Fusion) as well as the S-Max and Galaxy minivans. Production of the Mondeo shifted in 2013 to the company's plant in Valencia, Spain, which also handles the Kuga crossover and Transit Connect cargo van, and will soon take over the minivans from Genk as well. The move follows a similar decision undertaken by General Motors to close the Opelwerk plant in Bochum, Germany. It also reflects a scaling down of automobile production in Belgium specifically: although Audi still manufacturers in Brussels and and Volvo in Ghent, Opel closed its plant in Antwerp in 2000 and Renault ceased production in Vilvoorde back in '97. However Ford still maintains its famous proving ground half an hour to the north in Lommel, Belgium. News Source: AutovisieImage Credit: Kristof Van Accom / AFP / Getty Plants/Manufacturing Ford plant ford s-max ford galaxy