Ford Ranger F-100 on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

Ford Mustang Shelby GT500 has a bit of a dyno issue

We're of the mind that each and every dyno should come with Murphy's Law painted in big, visible letters down the side. For every ten successful dyno runs out there, it seems there's one where events to horribly wrong. Take, for example, the video below. The clip shows what happens when a Ford Shelby GT500 and a mobile dyno have a bit of a disagreement at the Performance Expo 24 in Sherbrooke, Quebec. We won't spoil the results for you, but we will say there's some substantial carnage involved.
It's unclear just how much damage ensues from the dust up or whether anyone was harmed in the incident, but from the looks of things, everyone made it out without serious injury. If only we could say the same for the machines involved. Check out the video below.

Ford trademarking 'Mach 1,' possibly for Mustang

A legendary name might be accompanying the redesigned, 2015 Mustang when it finally makes its world debut - Mach 1. Stumbled upon by the team at Ford Authority, the Mach 1 title was found in a trademark filing with the US Patent and Trademark Office, and would revive a name last used on the fourth-generation, 2003 Mustang.
While the the 2003 vintage was well and good, the Mach 1 is really remembered for a three-year run from 1969 to 1971 - it's best to just forget the emissions-choked 1972 to 1978 Mach 1s - when power output ranged from a modest 250 horsepower with the two-barrel, 351-cubic-inch Windsor V8 to "375 hp" (actual output was rumored to be well north of 400 horsepower) with the righteous, 429-cubic-inch Super Cobra Jet V8.
What does the title hold for the sixth-generation Mustang? It's tough to say. The fanatics at Ford Authority seem to think Mach 1 could take the place of the Shelby GT500 at the top of the Mustang hierarchy, which sounds like a valid argument. At the same time, we could see the SVT Cobra moniker returning for the flagship model, and the Mach 1 doing battle with the Chevrolet Camaro Z/28 (unless the Boss 302 were to return). Confounding things is the historical precedent - the Mach 1 was responsible for the death of the Mustang GT in 1969, so it might make sense as a volume performance model.