1964 Ford Truck F100 Long Bed 2 Wheel Drive on 2040-cars

Auto blog

Tier 1 suppliers call GM the worst OEM to work with

Among automakers with a big US presence, General Motors is the worst to work for, according to a new survey from Tier 1 automotive suppliers, conducted by Planning Perspectives, Inc.
The Detroit-based manufacturer, which has been under fire following the ignition switch recall and its accompanying scandal, finished behind six other automakers with big US manufacturing operations. Suppliers had issues with trust and communications, as well as intellectual property protection. GM was also the least likely to allow suppliers to raise their prices in the face of unexpected increases in material cost, all of which contributed to 55 percent of suppliers saying their relationship with GM was "poor to very poor."
GM's cross-town competitors didn't fare much better. Chrysler finished in fifth place, ahead of GM and behind Dearborn-based Ford, which was passed for third place this year by Nissan. Toyota took the top marks, while Honda captured second place.

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."

1964 Ford GT40 prototype to be auctioned in April

The Ford GT40 owns a firm spot on the list of the greatest American racecars ever made, being the first car from the United States to take an overall win in the 24 Hours of Le Mans. And now Mecum will auction what it claims is second-oldest GT40 still in existence at its Houston sale on April 12.
The story of the GT40 is fascinating. Henry Ford II attempted to buy Ferrari in the early '60s, but Enzo refused. Ford decided if he couldn't have them, then he would beat the Prancing Horse on the track. Ford went to Carroll Shelby and asked him to spearhead the program. The early cars combined a steel monocoque chassis with Ford's 4.2-liter V8 engine pumping out around 350 horsepower. The first prototype made its public debuted on April 1, 1964, at the New York Auto Show.
Shelby kept building prototypes, including GT/104, which is for sale here. This version featured a lighter steel chassis and was raced at Le Mans in 1964. However, a fire forced it to retire. It was then repainted and had a 4.7-liter (289-cubic-inch) engine fitted. The chassis had its best finish at the 1965 Daytona Continental 2,000 Kilometers where it finished third with Bob Bondurant and Ritchie Ginther behind the wheel. Later that season, it was shipped back to Ford where it was restored and displayed at auto shows until 1971 when the automaker sold it. Since then, it has had many private owners.