1961 Ford Unibody Hot Rod Pickup on 2040-cars

Auto blog

Nuclear-powered concept cars from the Atomic Age

In the 1950s and early 60s, the dawn of nuclear power was supposed to lead to a limitless consumer culture, a world of flying cars and autonomous kitchens all powered by clean energy. In Europe, it offered the then-limping continent a cheap, inexhaustible supply of power after years of rationing and infrastructure damage brought on by two World Wars.
The development of nuclear-powered submarines and ships during the 1940s and 50s led car designers to begin conceptualizing atomic vehicles. Fueled by a consistent reaction, these cars would theoretically produce no harmful byproducts and rarely need to refuel. Combining these vehicles with the new interstate system presented amazing potential for American mobility.
But the fantasy soon faded. There were just too many problems with the realities of nuclear power. For starters, the powerplant would be too small to attain a reaction unless the car contained weapons-grade atomic materials. Doing so would mean every fender-bender could result in a minor nuclear holocaust. Additionally, many of the designers assumed a lightweight shielding material or even forcefields would eventually be invented (they still haven't) to protect passengers from harmful radiation. Analyses of the atomic car concept at the time determined that a 50-ton lead barrier would be necessary to prevent exposure.

Ford recalls 434k vehicles for several unrelated issues

It seems that the hard winter in much of the country has been as rough on some Fords as it has on many people. The Blue Oval is recalling roughly 434,000 vehicles in two separate recalls, and one of them partially caused by the salt used to melt the snow on roads.
The first recall covers 385,750 2001-2004 Escape models in the Midwest, Northeast and Canada because a subframe could rust and eventually fail. This is partially due to the road salt used in those areas, and about 349,000 of the affected vehicles are in the US. To remedy the problem, dealers are installing a reinforcement cross brace on the frame to strengthen them. There has been one crash caused by the failure but no injuries. According to The Detroit News, this is not the first rust-related recall for Ford. It estimates the company has repaired over two million vehicles since 2010 for problems on vehicles related to the iron oxide, including the rear wheel wells of the Freestar minivan.
The second recall covers 48,950 2013-2014 Ford Fusion, Escape, C-MAX and Lincoln MKZ models because welds in their seatbacks don't meet National Highway Traffic Safety Administration standards. The fault affects the front seats, and the sub-standard welds joining the setback to the recliner could increase the chance on injury. There have been no reported injuries or accidents caused by the problem, but there are 42,972 affected vehicles in the US and 4,744 in Canada.

Ford recalls 600,000 older-model sedans for braking issue

Ford is recalling 600,166 older-model Ford, Lincoln and Mercury vehicles over an issue that could affect braking and increase the risk of a crash. The safety recall covers certain Ford Fusion, Mercury Milan and Lincoln MKZ sedans from the 2006 through 2010 model years that were built at Ford’s Hermosillo Assembly Plant in Mexico between Feb. 22, 2006, and July 15, 2009. Ford says a valve that is normally closed inside the hydraulic control unit may get stuck in the open position or be slow to close, which could make it harder to engage the brakes and increase risk of a crash. Ford says itÂ’s aware of 15 reports of accidents and two injuries possibly related to the issue. Dealers will inspect the hydraulic control unit for signs of the problem and replace it, if necessary. The dealers will pressure-flush the system with brake fluid and replace the reservoir cap with a new one. Ford is also issuing a small recall of 33 of its 2020 F-150 trucks in the U.S. and 51 in Canada over potentially damaged spare tires. It says the bead area on the tires may have been damaged when it was mounted onto the wheel assembly, leaving it vulnerable to corrosion, separation of the bead wire and ultimately a rapid loss of air pressure and detachment from the wheel. Dealers will replace the spare tire. Affected vehicles were built at the Dearborn Truck Plant from Nov. 10-21 of this year.