2001 Ford Explorer Xlt Sport Utility 4-door 4.0l on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford to build Explorer in Russia to meet demand [w/video]

The current Ford Explorer is sold in more than 64 countries, and this three-row vehicle continues to grow in popularity worldwide. To keep up with demand, Ford began producing the Explorer at Ford Sollers Elabuga Assembly Plant in Tatarstan, Russia, a joint venture facility. This partnership will build Russian-market Explorers only, and production of export vehicles not destined for Russian buyers will continue to be built at Ford's assembly plant in Chicago.
Before this plant went online, Ford would ship Explorers to Russia (and other regions around the world) as partially assembled knock-down units where final assembly would eventually take place. While there is no indication as to how many Explorers Ford Sollers will build for Russia, Ford did add that exports of the SUV were up 65 percent last year (from 2011) accounting for more than 24,000 units.
Scroll down for a press release about the Russian Explorer as well as a video (bad music and all) showing the SUV being produced in Tatarstan.

Project Ugly Horse: Part VI

Solid axle? What solid axle?
I was fully prepared to embark on a seven-day journey down a rabbit hole of broken bolts, internet hearsay and consternation.
This should not have gone this easily. Having a long and checkered history of simple projects punctuated by much wailing and gnashing of knuckles, I was fully prepared to embark on a seven-day journey down a rabbit hole of broken bolts, internet hearsay and consternation when I finally decided to lay hands on the '89 Mustang with the goal of relieving the car of its stock rear axle. Instead, it took less than a full morning's worth of work to carve the old 7.5-inch solid axle from its moorings and mock up something, well, different.