2014 Ford Escape Titanium on 2040-cars

Auto blog

Lincoln MKC recalled because start button located too close to touchscreen [UPDATE]

UPDATE: Ford spokesperson Kelli Felker responded to our questions and let us know that the fix for the push-button start on the 2015 MKC has the switch moved to the top of the of the column of gear shift buttons instead of the bottom. Owners should be notified about both campaigns "toward the end of February." After massive campaigns from General Motors and to fix Takata airbag inflators, 2014 will undoubtedly go down as The Year Of The Recall. And with little time to spare, Ford is getting in just under the wire to adding two more to its yearly total. The larger of the campaigns is actually one of the most bizarre campaigns we've heard of all year. Lincoln is recalling 13,574 units of its 2015 MKC compact crossover in North America to move the location of the push-button ignition switch on the dashboard. According to the automaker's announcement: "Due to the switch's close proximity to other controls, occupants are inadvertently shutting off the engine while driving." The button is located near the bottom of the touchscreen, which can apparently make it possible to hit by mistake. Back when Autoblog first drove the new MKC in June, we came away very impressed, but noted: "... we're still not completely sold on the aforementioned pushbutton transmission selector ... it still seems somewhat gimmicky and it can't be operated by feel alone, as you might when shifting a traditional console-mounted lever from Park to Drive." According to Lincoln, there have been no reported accidents or injuries stemming from this button misapplication. Of the affected vehicles, there are 11,144 in the US, 2,033 in Canada and 397 in Mexico. To fix the problem, dealers are moving the button to a different location and reprogramming the powertrain control module. According to Automotive News, models built since September already have a different layout. The change was reportedly done to match the rest of the Lincoln lineup. The second recall covers 12,205 units of the 2014 Ford Escape (2015 model year pictured below) and 2015 Lincoln MKC in North America because of a problem with nickel plating on the fuel pump. The issue can cause the pump to seize, which can cause the crossovers not to start or stall while driving. The automaker is not aware of any accidents or injuries related to this fault. Dealers are replacing the fuel deliver module to fix the situation. Of the affected vehicles, there are 9,038 in the US, 3,074 in Canada and 93 in Mexico.

These horribly misguided front-drive design studies nearly became the Mustang

As we eagerly await the unveiling of the all-new sixth-generation Mustang, Ford has been giving us some great information over the past few months showing what has gone into shaping its venerable pony car. As many changes as the Mustang has gone through in its 50 years, though, it appears the fourth-gen model played a decisive and pivotal role in the car's future.
As is part of Mustang lore, the front-wheel drive Ford Probe was originally developed as a next-generation Mustang in the Eighties before cooler heads prevailed. The Blue Oval has just released a handful of images showing how bad things could have been - including a full-scale clay model of a front-wheel-drive Mustang (shown above). Fortunately, the FWD Mustang plan was scrapped and Ford went to work designing a rear-wheel-drive replacement for the Fox Body Mustang, with three design studies making it far enough to become full-scale models. These include the soft "Bruce Jenner" Mustang, the over-the-top "Rambo" Mustang and the middle-ground "Arnold Schwarzenegger" Mustang, which finally became the basis for the 1994 'Stang.
By early 1991, the design language of the fourth-generation Mustang had been worked out, and the rest, they say, is history. Scroll down for the fascinating press release telling the story of the fourth-gen Mustang, and be sure to check out the gallery of horribly misguided sketches and various design studies that were all on the table in the late 1980s.

Ford recalls 9,900 vehicles across two campaigns

Ford is recalling a total of 9,885 vehicles in two campaigns. The Basics: In one recall, Ford will recall 9,017 examples of the 2013 Escape with build dates from January 11, 2012, to April 1, 2013, and the 2013-2014 Focus ST produced between May 3, 2012, and October 14, 2013. The Problem: Splices in the engine wiring harness might not have enough compression, and this can cause the manifold absolute pressure sensor to send incorrect signals to the powertrain control module. This issue could cause the engine to stall. Injuries/Deaths: None reported. The Fix: Dealers will replace the current crimped splices with new splices, according to the National Highway Traffic Safety Administration. If You Own One: The repair campaign will begin on January 4, 2016. More Information: Ford recalled the 2013 Escape and Focus ST in August 2014 for the same problem, and this is an expansion of that campaign, according to company spokesperson John Cangany to Autoblog. The Basics: In the smaller of the two campaigns, Ford will recall 868 examples of the 2013 Explorer, Explorer Police Utility, Taurus, Taurus Police Interceptor, Flex, Lincoln MKS, and MKT. The Problem: The fuel delivery module can crack, which would cause a fuel leak. Injuries/Deaths: None reported. The Fix: Dealers will replace the fuel delivery module. If You Own One: Owners should receive notice soon because NHTSA's report says the recall begins in December. More Information: According to Cangany, this recall is an expansion of a campaign from 2013 for these vehicles. RECALL Subject : Engine Wiring Splices may cause Stall Report Receipt Date: DEC 02, 2015 NHTSA Campaign Number: 15V813000 Component(s): ELECTRICAL SYSTEM Potential Number of Units Affected: 9,017 All Products Associated with this Recall Vehicle Make Model Model Year(s) FORD ESCAPE 2013 FORD FOCUS 2013-2014 Details Manufacturer: Ford Motor Company SUMMARY: Ford Motor Company (Ford) is recalling certain model year 2013 Escape vehicles manufactured January 11, 2012, to April 1, 2013, and 2013-2014 Focus ST vehicles manufactured May 03, 2012, to October 14, 2013. Insufficient compression in the engine wiring harness splices to the Manifold Absolute Pressure (MAP) sensor may provide incorrect signals to the powertrain control module (PCM). CONSEQUENCE: The incorrect signals could cause the vehicle to hesitate or the engine to stall, increasing the risk of a crash.