2005 Ford Escape Xlt on 2040-cars

Auto blog

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.

Automakers' rush on aluminum may result in shortage

Aluminum is the new buzzword in the automotive industry. The latest Range Rover and Range Rover Sport both take advantage of the lightweight material to shave huge amounts of body fat (only it's called "aluminium" over there). Audi and Jaguar have been using the stuff for years in their A8 and XJ, respectively, and now, aluminum is going mainstream, arriving on the 2015 Ford F-150.
While we're excited to see aluminum make an impact outside the premium market, its widespread adoption apparently won't come without some problems, notably in terms of supply. "There isn't an automotive manufacturer that makes vehicles in North America that we're not talking to," Tom Boney, of Novelis, the largest global supplier of aluminum sheetmetal, told The Detroit News.
According to Boney, Ford's use of aluminum on such a large scale has forced auto manufacturers in "every boardroom" to reconsider their plans following the F-150's unveiling, for one simple reason: there's not exactly enough aluminum to go around, at least in the short term. The auto industry presently only accounts for six percent of the aluminum sheet produced, but as the material is adopted by more and more brands, that figure is expected to swell to 25 percent within the next six years.

This 2,000-hp Mustang is in serious need of wheelie bars

The Ford Mustang on the right is drag racing with the standard technique. The Mustang on the left, driven by David Measell, is using a new "rear bumper only" technique that evidently surprised everyone at the South Georgia Motorsports Park strip - including Measell.
Measell said his outfit just bought the car the week before the event, noting that it has more than 2,000 horsepower. Speaking of his "flying" run, Measell said, "We turned it up to dip on down," by which he meant they turned up the power in order to get his time down. Turns out all that power and all that traction sent the nose straight up into the air almost as soon as the race began.
He told an interviewer afterward that this was his first race in a "regular car" since he normally drives a pro-mod. "I like my wheelie bars," he concluded. You can see how he got there in the video below.