2008 Ford Edge on 2040-cars

Auto blog

Fitting Retirement: Grand Marquis last Mercury off the line

The signs have come down and retail production ended back in October of 2010. Now, the very last Mercury model has rolled off the assembly line. This last Mercury somewhat fittingly takes the form of a Grand Marquis reporting for fleet duty. It was built at the St. Thomas plant in Ontario, Canada, which is the same facility that continues to produce the Ford Crown Victoria and Lincoln Town Car for fleet and livery duty.
St. Thomas' days are numbered, however, as the factory is slated to close on August 31. When it goes, the Panther platform is likely to follow. So long, and thanks for all the fish memories.
[Source: Autoweek]Read | Permalink | Email this | Comments

10 automakers shack up in Detroit hotel to talk Takata airbags

Since Takata has decided not to take the lead concerning potential issues with its airbag inflators, the automakers have. Perhaps that's unsurprising, since it's the automakers, not Takata, that will take a beating on the dealership floor if consumers decide its models are a health hazards. The Detroit News reports that Toyota, Honda, General Motors, Ford, Chrysler, Mazda, BMW, Nissan, Mitsubishi and Subaru met in a hotel conference room near the Detroit Metropolitan Airport last week to sort out a way to understand the technical issues involved. So far, faulty airbag inflators have been ruled the cause of five deaths and 50 injuries around the world, but neither Takata nor investigators understands exactly why the inflators are malfunctioning. The National Highway Traffic Safety Administration recently asked Takata to issue a national recall, Takata declined, citing a minuscule failure rate and the fact that it's still investigating the issue. Toyota and Honda then made an industry-wide appeal for "a coordinated, comprehensive testing program" that would pinpoint the problem inflators and get them replaced, and that's what the Detroit meeting was about. Numerous issues, however, will make this a long row to hoe: simply getting the parts to replace the nearly 20 million inflators in cars recalled around the world so far - even working with other suppliers - will take a years, but more importantly, no one knows if the replacement inflators currently being installed will suffer the same issue. Answers will hopefully come quickly with Takata, the ten automakers and NHTSA all independently investigating the problem.

Ford finds flex-fuel engine design plays big role in emissions output

How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.