09 Ford E-250 Cargo Van - Clean Florida Owned Van on 2040-cars

Auto blog

NHTSA closes rollaway investigation into 1.56M Ford SUVs

It's taken four years of study, but the National Highway Traffic Safety Administration has finally closed the books on its investigation into rollaway accusations surrounding 1.56-million Ford SUV models.
The probe, which centered on the 2002-2005 Ford Explorer, 2002-2005 Mercury Mountaineer and 2003-2005 Lincoln Aviator, ends without the federal agency calling for a recall. According to The Detroit News, the investigation was closed due to a "low number of complaints" - NHTSA documented 180 such complaints that resulted in 14 crashes and six minor injuries, but the number of incidents have been slowing. The suspected defect rate for the trucks' automatic transmissions was found to be 4.4 per 100,000 units, and the brake-shift interlock mechanism failure rate was judged to be even lower at 3.4 per 100k.

Rising aluminum costs cut into Ford's profit

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.

Ford to spread all-wheel drive across performance range

Car and Driver took a closer look at the all-wheel-drive system in the Focus RS, Ford reps having made "broad hints" about it being applied to other performance vehicles. One spokesperson even said that he "can see this as one of those technologies of the future." That would make sense because, as C/D notes, it couldn't have been an inexpensive job to engineer the torque-vectoring unit for the Focus – one that can send 70 percent of torque to the rear wheels, and send 100 percent of that portion to either wheel if needed. C/D also clues into the system's close similarity to the AWD unit in the recently updated Range Rover Evoque, which is manufactured by Sweden's GKN Driveline. In the Evoque, torque vectoring is brake based and two electronically controlled clutches turn the Range into a front-wheel-drive crossover under 22 miles per hour. Ford wouldn't comment on the GKN Driveline connection, or even if there is one. No matter where it might come from, more performance Fords are good for every enthusiast, and we do not look an AWD, torque-vectoring gift horse in the mouth. Featured Gallery 2016 Ford Focus RS News Source: Car and Driver Ford Technology Hatchback Performance