Crown Victoria Sedan P71 Interceptor on 2040-cars

Auto blog

BMW to follow Honda back into F1?

The economic downturn wrought devastating effects on motor racing. Formula One alone lost half its engine suppliers when Honda left at the end of the 2008 season, and both BMW and Toyota followed at the end of 2009. But things are looking up again. Cosworth may have dropped out this season, reducing the engine suppliers to three: Ferrari, Renault and Mercedes, the latter of which admits that it may have left had the engine formula not changed. But Mercedes has stayed and is dominating the championship. Honda is coming back next season. And word around the paddock is it may not be the only one.
According to Giancarlo Minardi - founder of the team now known as Scuderia Toro Rosso - BMW engineers have been conspicuously spotted lately at F1 test sessions and grands prix, lending to speculation that the new engine regulations may entice the Bavarian automaker back into the series. According to Minardi, BMW's marketing division is pushing for the automaker's return to F1, with the board slated to make a decision in May. BMW would be more likely to consider an engine-supply deal rather than taking a team over like it had with Sauber, but with which team or teams it might collaborate remains a big question mark at this point.
As if that's not enough, Ford is said to be considering taking over Cosworth's aborted V6 turbo engine program to take both outfits back into the sport as well. Cosworth supplied F1 engines under the Ford banner for years, but returned under its own name for four seasons from 2010 through 2013 before shuttering its program to develop an engine to meet the new regulations adopted this season.

2015 Roush Mustang lineup officially revealed

Just last week, Saleen revealed initial details of its tuning program for the new Ford Mustang. And now Roush is following suit.
Available in three stages - based on the V6 (RS), EcoBoost (RS1) and V8 (RS2) models - the 2015 Roush Mustangs all feature the venerable Ford tuner's latest R7 aero kit complete with remodeled fascia, five-blade grille, gaping air dam with integrated driving lamps and splitter. Around back there's a one-piece deck spoiler and "race-inspired lower aero-valance."

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.