1999 Ford Crown Victoria Base Sedan 4-door 4.6l on 2040-cars

Auto blog

NHTSA advances investigation of Ford Crown Victoria headlights

The National Highway Traffic Safety Administration is opening a preliminary evaluation into reports of suddenly failing headlights on 517,945 examples of the 2003-2005 Ford Crown Victoria and Mercury Grand Marquis. The government started looking into this problem in April when the North Carolina Consumers Council filed a defect petition with the agency. Now, the inquiry has moved to the next step. According to NHTSA's documentation (as a PDF), it examined its own database and worked with Ford to come up with a total of 3,609 complaints of the front lighting control module suddenly failing. When this happens, drivers lose the low-beam headlights, but the high-beams can be used by holding the stalk. Sometimes turning the switch off and on fixes the issue. Additionally, there are 15 allegations of crashes, and one reported shoulder injury. NHTSA's preliminary evaluations "evaluate the scope, frequency, and consequence of the alleged defect" and don't necessarily lead to a recall. NHTSA looked into this problem once before in 2008 and 2009 and decided that a recall wasn't necessary. Ford also extended the warranty on the front lighting control module for these vehicles. INVESTIGATION Subject : Loss of headlights Date Investigation Opened: AUG 10, 2015 Date Investigation Closed: Open NHTSA Action Number: PE15028 Component(s): EXTERIOR LIGHTING All Products Associated with this Investigation Vehicle Make Model Model Year(s) FORD CROWN VICTORIA 2003-2005 MERCURY GRAND MARQUIS 2003-2005 Details Manufacturer: Ford Motor Company SUMMARY: After receiving a defect petition (DP15002) concerning the loss of headlights and other exterior lighting in model year (MY) 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles, the Office of Defects Investigation (ODI) analyzed Vehicle Owner Questionnaire (VOQ) complaints received from consumers and identified a total of 605 reports (for all submission dates) alleging headlight failure. The complaints indicate failures of both low beam headlights typically while driving, a defect condition that was evaluated under a prior ODI investigation (PE08066). Most consumer VOQs indicate that the headlights failed suddenly and without warning leaving the driver with no forward lighting, however some report the headlights flickered or dimmed prior to turning off. In some cases drivers were able to turn the headlights back on after a period of time while others reported the headlights would not come back on at all.

Ford launches pair of recalls affecting fullsize sedans and Transit Connect van

Ford has announced a pair of pretty significant recalls affecting the 2010-2013 Ford Taurus and Police Interceptor, as well as their platform-mate, the Lincoln MKS. A separate recall covers the 2014 Transit Connect. The fullsize sedans include 205,000 vehicles built at Chicago Assembly over a variety of timeframes, ranging between December 1, 2009 and November 30, 2012. The vehicles, 194,889 of which were sold in the United States, have an issue with the spring controls on the interior door handles that could cause the door to open in a side-impact crash. The Transit Connect recall, meanwhile, includes 16,100 vans built between November 6, 2013 and September 20,2014 at the company's Valencia, Spain factory. In these vehicles, the seatbelt fasteners may not have been tightened properly, which could cause them to loosen over time, a condition that's obviously bad news in the event of a crash. Ford says it is not aware of any accidents, injuries or crashes in either recall. Owners will, of course, be notified and asked to report in for inspections and if necessary, free replacements. Scroll down for the full press release from Ford, which includes the complete breakdown of dates during which the affected sedans were built in Chicago. JAN 28, 2015 | DEARBORN, MICH. FORD ISSUES TWO SAFETY RECALLS Ford is issuing two safety recalls. No accidents or injuries are attributed to either of these conditions. Details are as follows: Ford issues safety recall for certain 2010-2013 Ford Taurus, Lincoln MKS and Ford Police Interceptor sedans for interior door handle issue Ford is issuing a safety recall for approximately 205,000 2010-2013 Ford Taurus, Lincoln MKS and Ford Police Interceptor sedans due to an issue with the spring that controls the interior door handles. If the spring is unseated, the door may become unlatched in a side-impact crash, increasing the risk of injury. Ford is not aware of any accidents or injuries related to this condition. Affected vehicles include certain 2010-2013 Ford Taurus vehicles built Dec. 1, 2009 to July 31, 2010 and Feb. 1, 2011 to Nov. 30, 2012 at Chicago Assembly Plant; certain 2010-2013 Lincoln MKS vehicles built June 2, 2011 to Oct. 31, 2011 at Chicago Assembly Plant; and certain 2010-2013 Ford Police Interceptor sedans built Dec. 1, 2009 to July 31, 2010 and Feb. 1, 2011 to Nov. 30, 2012 at Chicago Assembly Plant.

This is what a 3D-printed liquid metal Ford Torino looks like

Artist Ioan Florea has encapsulated a 1971 Ford Torino with 3-D-printed liquid metal transferred onto the car using technology that he developed, and the result is a stunningly shiny, seamless design.
"The surface has the highest coefficient of reflectivity never achieved before," Florea told us in an e-mail, using "nano-materials and nano-pigments that create an internal three-dimensional structure and dictate the polymer how to behave." Sure... We'll leave it to him to make any more 3-D-printed liquid metal-transferred art pieces.
Florea grew up in Romania, and the motivation behind picking the old Ford as his canvas came from his childhood memories of what an American car is - "big and wide and fascinating," he says - and the European name of the car itself, which it shares with an Italian city.