Red Xlt Explorer Sport 302 Automatic 4wd Power Steering on 2040-cars

Auto blog

An amazing Group B rally car collection heads to auction

Kicking off in 1982, the Group B era spawned some of the most fearsome rally cars of all time. The technologically advanced pioneers of all-wheel drive and turbocharging defined a time when automakers had carte blanche to build machines with unrestricted power, without the burden of homologating a large number of road cars to qualify. The results were sometimes deadly, leading the FIA to ban the class after 1986. Now, a collection of seven Group B monsters is headed across the block in Paris as part of the Artcurial auction, held in partnership with France's famed Retromobile show. The show has been delayed to June, however. There's a 1985 Peugeot 205 Turbo 16, one of 20 Evo II models that helped the company achieve two championships in Group B's short run. This particular example was driven by world champion Timo Salonen at the 1986 Swedish Rally, where it finished seventh due to an oil filter seal failure. Bruno Saby subsequently drove it at the 1986 Tour de Corse and Peugeot entered it at the 1986 Acropolis Rally as well. It's still registered to Peugeot Talbot Sport and represents a French technological achievement, according to Artcurial, comparable to the Concorde or TGV train. Representing Italy are a pair of Lancias in the iconic Martini livery. The Lancia 037 helped Bel Paese clinch its only Group B victory in 1983, after a hard-fought rivalry with Audi. It's one of the few Group B cars that weren't AWD, achieving its success the old-fashioned way, through lightness and superb handling. A second Lancia, a 1986 Delta S4, was the culmination of the Italian firm's later Group B efforts and one of Saby's favorites. While Group B was no more in 1987, the S4 was the predecessor to the Delta Integrale that would dominate WRC from 1987 through 1992. While the collection also includes greats like a Ford RS200, Renault 5 Maxi Turbo, and MG Metro 6R4, the centerpiece is the Audi Quattro Sport S1. The ultimate Group B machine, it introduced all-wheel-drive and turbocharging to the sport. It also employed the wildest use of wings and air dams to generate downforce. Tunable up to 590 horsepower, it could rocket to 60 mph in about three seconds. The car offered for sale came straight from Ingolstadt, a 1988 model built for the Race of Champions of ex-Group B cars. The collection was amassed in the late 80s and early 90s, not long after Group B's dissolution.

Ford recalls 434k vehicles for several unrelated issues

It seems that the hard winter in much of the country has been as rough on some Fords as it has on many people. The Blue Oval is recalling roughly 434,000 vehicles in two separate recalls, and one of them partially caused by the salt used to melt the snow on roads.
The first recall covers 385,750 2001-2004 Escape models in the Midwest, Northeast and Canada because a subframe could rust and eventually fail. This is partially due to the road salt used in those areas, and about 349,000 of the affected vehicles are in the US. To remedy the problem, dealers are installing a reinforcement cross brace on the frame to strengthen them. There has been one crash caused by the failure but no injuries. According to The Detroit News, this is not the first rust-related recall for Ford. It estimates the company has repaired over two million vehicles since 2010 for problems on vehicles related to the iron oxide, including the rear wheel wells of the Freestar minivan.
The second recall covers 48,950 2013-2014 Ford Fusion, Escape, C-MAX and Lincoln MKZ models because welds in their seatbacks don't meet National Highway Traffic Safety Administration standards. The fault affects the front seats, and the sub-standard welds joining the setback to the recliner could increase the chance on injury. There have been no reported injuries or accidents caused by the problem, but there are 42,972 affected vehicles in the US and 4,744 in Canada.

Ford cleans up painting process with cameras

Knowing how the bacon gets made rarely entices us and, in the same vein, the same usually goes for knowing about how new cars get painted. But in both instances, however, quality - or a lack thereof - is instantly obvious. In terms of the latter, Ford is showing off its new paint quality process with 3D Dirt Detection Technology to find imperfections in vehicle paint more easily and more quickly.
This process - being performed on the F-150 SVT Raptor above - uses 16 computer-controlled cameras to create a three-dimensional model (inset) of the vehicle to detect flaws in the paint including dirt particles, which can then be buffed out manually. Ford says this new technology cuts down on time spent looking for paint flaws and gives workers more time to correct those that are discovered.
Currently, Ford only uses its 3D Dirt Detection Technology system at three factories (the Dearborn, MI facility, along with those in Louisville, Kentucky and Valencia, Spain), but it will soon spread to five more plants in North America. Ford has released a video and press release for this innovative and unexpectedly interesting process, both of which are posted below.