1982 Ford Bronco Custom Sport Utility on 2040-cars

Auto blog

Ford Mustang Mach-E fails Sweden's moose test

The infamous moose test has claimed another casualty. This time it's the Ford Mustang Mach-E AWD Long Range, which was tested in an electric four-way alongside the Tesla Model Y, Hyundai Ioniq 5 and Skoda Enyaq iV (an electric utility vehicle closely related to the Volkswagen ID.4 that is sold in the United States). According to the Swedish testers at Teknikens Varld, Ford's electric car not only failed to hit the speed necessary for a passing grade, it didn't perform well at slower speeds, either. To pass the outlet's moose test, a car has to complete a rapid left-right-straight S-shaped pattern marked by cones at a speed of at least 72 km/h (44.7 miles per hour). The test is designed to mimic the type of avoidance maneuver a driver would have to take in order to avoid hitting something that wandered into the road, which in Sweden may be a moose but could just as easily be a deer or some other member of the animal kingdom elsewhere in the world, or possibly a child or car backing into the motorway. Not only is the maneuver very aggressive, it's also performed with weights belted into each seat and more weight added to the cargo area to hit the vehicle's maximum allowable carrying capacity. The Mustang Mach-E only managed to complete the moose test at 68 km/h (42.3 mph), well below the passing-grade threshold. Even at much lower speeds, Teknikens Varld says the Mach-E (which boasts the highest carrying capacity and was therefore loaded with more weight than the rest of the vehicles tested in this quartet) is "too soft in the chassis" and suffers from "too slow steering." Proving that it is indeed possible to pass the test, the Hyundai and Skoda completed the maneuver at the 44.7-mph figure required for a passing grade and the Tesla did it at 46.6 mph, albeit with less weight in the cargo area. It's not clear whether other versions of the Mustang Mach-E would pass the test. It's also unknown if Ford will make any changes to its chassis tuning or electronic stability control software, as some other automakers have done after a poor performance from Teknikens Varld, to improve its performance in the moose test. Related video:

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.

Ford Recalls Nearly 435,000 Vehicles

Ford is recalling nearly 435,000 cars and SUVs to fix rusting frame parts or faulty seats. The biggest of the two recalls covers nearly 386,000 Ford Escapes from the 2001 through 2004 model years. Ford says the subframes can rust, allowing a control arm to separate and hamper steering control. Ford is aware of one crash but no injuries linked to the problem. The SUVs were originally sold or registered in 20 states and Washington, D.C., where salt is used to clear snow and ice from roads. Six Canadian provinces also are included. Dealers will install a reinforcement brace to fix the problem. The Escapes covered by the recall were built from Oct. 22, 1999 through Dec. 19, 2003 at the Kansas City Assembly plant, and from May 1, 2003 through Jan. 23, 2004 at the Ohio Assembly plant, Ford said in a statement issued Monday. They were originally sold or registered in Connecticut, Iowa, Minnesota, Ohio, Wisconsin, Delaware, Maine, Missouri, Pennsylvania, Maryland, New Hampshire, Rhode Island, Illinois, Massachusetts, New Jersey, Vermont, Indiana, Michigan, New York, West Virginia and Washington, D.C. Also covered are Escapes sold or registered in Ontario, Quebec, Prince Edward Island, New Brunswick, Nova Scotia, and Newfoundland & Labrador. The second recall covers 49,000 Ford Fusion, Lincoln MKZ, Ford Escape and C-MAX vehicles from 2013 and 2014. Dealers will replace seat back frames that weren't welded properly. No crashes or injuries have been reported from the problem, Ford said. Recalls Ford