1981 Ford Bronco Custom Sport Utility 2-door 5.8l on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford dealers offered discounts on tools to fix aluminum

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.

NHTSA closes book on Ford, GM probes of 600,000 vehicles

US safety regulators have closed a pair of investigations into some 500,000 Ford Crown Victoria, Mercury Grand Marquis and Marauder sedans built between 2004 to 2007, and 100,000 Chevrolet Impala models from 2014. The Ford investigation focused on rusting heat shields, which may become dislodged and jam the steering, according to Reuters. The National Highway Traffic Safety Administration found that this happened very rarely. In fact, of the ten incidents filed with the government safety watchdog, six came from a single police department, which evidently had some sort of problem with its reporting. As for the Impala, the NHTSA investigators attributed two incidences of "unintended autonomous braking" to user error. In both cases, the vehicles were involved in rear-end collisions. According to GM investigators, it's believed that drivers accidentally activated the electric parking brake, causing the collisions. The vehicles in question were rental cars. Featured Gallery Ford Crown Victoria Related Gallery 2014 Chevrolet Impala View 10 Photos News Source: ReutersImage Credit: Ford, Chevrolet Government/Legal Chevrolet Ford Safety Sedan ford crown victoria mercury grand marquis