One Owner Loaded Fiat Abarth Hatchback, Low Miles, Priced To Move! on 2040-cars

Auto blog

FCA recalls 894k total vehicles worldwide in two campaigns

FCA is recalling a total of 893,698 vehicles worldwide in two campaigns to fix problems with inadvertent airbag deployment, failure of the anti-lock brakes, and stability control systems in the Jeep Grand Cherokee, Liberty, Dodge Journey, and Fiat Freemont. 559,703 of these vehicles are in the US. The larger recall affects 284,089 examples of the 2003 Jeep Liberty and 2004 Jeep Grand Cherokee, and there are also 13,411 of them in Canada, 6,277 in Mexico, and 48,212 outside the NAFTA region. Because of "electrical noise beyond the tolerance of the airbag electronic control module", part of that component can fail, according to the National Highway Traffic Safety Administration. This can cause the front and side airbags to deploy and the seatbelt pre-tensioners to activate inadvertently. FCA US has seven reports of alleged injuries from this problem. To fix the situation, the Jeeps need their Occupant Restraint Control modules replaced, as well as the front- and side-impact sensors. According to the NHTSA, the replacement parts won't be available until early 2016. Still, FCA US will advise owners about the problem in a letter by the end of December and will send a second notification when the components are ready. The second campaign affects 275,614 examples of the 2012-2015 Dodge Journey in the US; plus 78,148 of them in Canada, 36,471 in Mexico, and 151,476 left-hand drive units outside of NAFTA where it's sold as the Fiat Freemont. On these vehicles, water intrusion can disable the anti-lock brakes and electronic stability control, although a warning light often illuminates when this issue occurs, and the problem doesn't affect regular braking. There are also no reports of injuries or accidents. To fix the issue, dealers will seal the ABS wiring harness and will replace any already affected components as necessary, like the ABS module or the headlamp and dashboard wiring harness. Statement: Occupant Restraint Control Modules October 30, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 284,089 older-model SUVs in the U.S. to replace their Occupant Restraint Control (ORC) modules and front and/or side-impact sensors, as required. Within this vehicle population, FCA US became aware of seven injuries caused by inadvertent air-bag deployments and advised NHTSA accordingly. The affected vehicles are not equipped with Takata Corp. air-bags. The Company is unaware of any related accidents.

Fiat's Marchionne ponders Chrysler going public again

Fiat boss Sergio Marchionne says there's a real possibility that its majority-owned Chrysler Group may eventually return to the ranks of publicly traded companies. According to Bloomberg, the Fiat and Chrysler CEO gives that a "50 percent chance" of happening, but he doesn't appear to favor that scenario: "My preference is to be one single company... we belong together."
Marchionne has seemingly been operating under the assumption that Fiat will eventually own all of Chrysler, working to buy up the shares it doesn't own and looking to buy out the retiree trust fund that it shares Chrysler ownership with. Certainly, Chrysler going independent again would be increasingly difficult, as the companies continue to blend products, technologies, facilities and staffing, a trend started immediately after the Italian automaker became custodian of the brand following Chrysler's bankruptcy in 2009.
Marchionne's remarks to the media came at Chrysler's Kokomo, Indiana plant, where he was on hand to announce a major investment at four facilities in the state to build eight- and nine-speed automatic transmissions.

Ralph Gilles named Fiat Chrysler head of design

The amalgamation of two major automakers like Fiat and Chrysler inevitably means that there'll be some redundancy. There can't be two design chiefs for the entire group, for example, so the Italian-American automaker has named just one to oversee all design for its various divisions – and that one individual is Ralph Gilles. A Chrysler group veteran, Gilles has been at Auburn Hills since 1992, and has held a number of key positions along the way. He has until now served as senior vice president in charge of what's now known as the FCA North American Design Office – a position he assumed in June 2009 when it was still just the Chrysler design office – and has previously run the Dodge and SRT brands and headed up the company's racing activities. In assuming his new role as the group's Head of Design, Gilles will also step up to the FCA Group Executive Council. Meanwhile Lorenzo Ramaciotti, who joined Fiat as head of design in 2007 after serving the same function at Pininfarina, is now set to retire. Along with the Gilles appointment and Ramaciotti retirement, FCA has named Mauro Fenzi as group COO Systems and head of Comau, Fiat's robotic machinery division. FCA Announces Executive Changes - Appoints Gilles as Chief Designer - Names Fenzi COO Systems and CEO of Comau April 1, 2015 , London - Fiat Chrysler Automobiles N.V. (NYSE: FCAU / MI: FCA) today announced that Ralph Gilles was named Head of Design and member of the FCA Group Executive Council (GEC). He currently leads the FCA North American Design Office as Senior Vice President, a position he was named to in June 2009. The GEC is the highest management-level decision making body within the FCA organization and is led by the FCA Chief Executive Officer (CEO). Gilles succeeds Lorenzo Ramaciotti, who is retiring after several years of dedicated service with the Company. Ramaciotti will continue to lend his expertise to the group serving as a Special Advisor to the CEO. "We extend our sincere appreciation to Lorenzo for his unwavering dedication, service, leadership and many contributions to the organization," said Sergio Marchionne, Chief Executive Officer, Fiat Chrysler Automobiles N.V. Gilles previously served as CEO – Motorsports; President and CEO – SRT Brand and CEO – Dodge Brand for FCA US in addition to his leadership role in Design. He joined the Company in 1992.