Find or Sell Used Cars, Trucks, and SUVs in USA

2000 Dodge Viper R/t-10 Convertible 2-door 8.0l on 2040-cars

Year:2000 Mileage:14875 Color: Red /
 Brown
Location:

USA, United States

USA, United States
Advertising:
Fuel Type:GAS
Engine:8.0L 7990CC 488Cu. In. V10 GAS OHV Naturally Aspirated
Vehicle Title:Clear
Transmission:Manual
Body Type:Convertible
For Sale By:Private Seller
VIN: 1B3ER65E1YV604840 Year: 2000
Make: Dodge
Number of Doors: 2
Model: Viper
Mileage: 14,875
Trim: R/T-10 Convertible 2-Door
Exterior Color: Red
Interior Color: Brown
Drive Type: RWD
Number of Cylinders: 10
Options: Leather Seats, Convertible
Disability Equipped: No
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

Please contact me before bidding, final price is 26,OOOK.

This Viper is 1 of 255 produced in 2000 with the red paint, It also has the 
Conley interior (saddle color) this makes it 1 of 76. 14800 miles, one of the 
lowest millage best condition Vipers in the west. I have both the hard top as 
well as the fold up soft top that fits in the trunk. I do have the original 
wheels and tires, I would drop the price down $500.00 if you are only 
interested buying it with the original wheels. This is a no problem, no 
stories car.
CD Player
Leather Seats
Power Mirrors
Tilt/Telescope Steering Wheel

Auto blog

Watch Jay Leno drive an ex-highway patrol '61 Dodge Polara

Tue, May 17 2016

The latest vehicle to swing by Jay Leno's Garage is a 1961 Dodge Polara. This one was used by the California Highway Patrol half a century ago, ordered specially by the state police instead of the Darts that were usually used by law-enforcement. After sitting out in the sun for a few decades, it recently underwent a comprehensive, ground-up restoration by the historians and craftsmen at the Automobile Club of Southern California. As you can see for yourself, the result of the restoration is really quite stunning. The ACSC apparently spared no expense, bringing the 413-cubic-inch V8 back up to working order, along with the emergency lighting, radio, certified speedometer... the works. In the process they even found the engine cranked out more than the factory quote of 325 horsepower, recording 332 hp and 406 pound-feet of torque on the dyno. The Polara CHP cruiser hadn't even been back out on the freeway since the restoration was finished. But after getting the full run-down from the guys responsible for its resuscitation, Jay wasted little time in bringing it back to its natural habitat.

Mopar unveils Dodge Challenger Drag Pak [w/video]

Sat, Jun 27 2015

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

2015 Dodge Charger R/T NHRA Funny Car burns rubber into SEMA [w/video]

Tue, 04 Nov 2014

Fiat Chrysler Automobiles is showing off a completely redesigned Dodge Charger Funny Car at this year's SEMA Show in Las Vegas and it's ready to blow through the NHRA timing lights next year. Initially, the shape might look like any of the other entrants in its class burning through the quarter mile, but this is the first comprehensive rethink for the racecar's aerodynamics since 2006, says Dodge.
Draped in classy red and black Mopar livery, the 2015 Dodge Charger R/T NHRA Funny Car tries to share the front and rear styling with its roadgoing counterpart, plus the scallops along the side, but this racer is all about crossing the finish line first.
The major goals for the redesign included making the body stronger and lighter without sacrificing aerodynamics, and that has been done with materials like Kevlar and carbon fiber. However, engineers have accomplished even more. By moving the cockpit further back, they've increased engine clearance and improved driver visibility.