Dodge Freightliner Mercedes Sprinter 10 Pass. Van 55,000 Miles / Low Reserve!!! on 2040-cars

Auto blog

FCA updates 700k-vehicle recall to replace ignition switches

FCA US is revising a previously announced recall of 702,578 minivans and SUVs; now specifying that owners replace their ignition switches, rather than just a component. The campaign affects the 2008-2010 Chrysler Town & Country, 2008-2010 Dodge Grand Caravan and 2009-2010 Dodge Journey. The National Highway Traffic Safety Administration initially opened an investigation last summer following complaints about the ignition switches in these models. FCA US (then Chrysler Group) responded with a recall of 695,957 examples of these vehicles because the key could appear to be in the "Run" position but not be fully engaged. If it slipped out, and there was an accident, then the airbags might not deploy. The company had initially planned to install a new detent ring to fix the problem. According to the timeline in a NHTSA document (available here as a PDF), the government agency and FCA US continued their research into the problem. The automaker found that the time needed to create a new ring design and updated software would be longer than replacing the whole ignition switch. The company worked with the supplier Marquardt to negotiate an accelerated schedule to manufacture the extra replacement parts. According to NHTSA, the investigation has now been closed because of FCA's recall. Company spokesperson Eric Mayne confirms to Autoblog via email, "No additional vehicles are affected and all affected customers have already been made aware their vehicles are subject to recall." FCA US sent out an initial notification advising owners of the problem in September 2014. The company will now send out a second letter in April and will replace the parts in two phases. Repairs for affected models from the 2008 and 2009 model years will begin in April, and 2010 examples will start being fixed in August. RECALL Subject : Ignition Switch may Turn Off , 1 INVESTIGATION(S) Report Receipt Date: JUN 26, 2014 NHTSA Campaign Number: 14V373000 Component(s): AIR BAGS , ELECTRICAL SYSTEM Potential Number of Units Affected: 702,578 All Products Associated with this Recall Vehicle Make Model Model Year(s) CHRYSLER TOWN AND COUNTRY 2008-2010 DODGE GRAND CARAVAN 2008-2010 DODGE JOURNEY 2009-2010 Details Manufacturer: Chrysler Group LLC SUMMARY: This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key.

Dodge Viper to out-Hell the Hellcat with supercharged V10?

The Viper wouldn't be the Viper if it wasn't the most powerful model under the Chrysler umbrella. But with the arrival of the Hellcat engine in the Dodge Charger and Challenger, the Viper has fallen behind in the bragging rights department: where the new supercharged V8 produces 707 horsepower and 650 pound-feet of torque, the naturally aspirated V10 offers "only" 640 hp and 600 lb-ft - gargantuan output figures by almost any other standard, but crucially behind on the SRT power scale. Conner Avenue is going to have to do something about that.
Although the Hellcat's engine reportedly won't fit under the Viper's hood, SRT is now rumored to have another trick up its sleeve: supercharge the existing V10. According to the Pentastar performance enthusiasts at allpar.com, Chrysler has already taken delivery of the first such prototype engines so that it can begin the process of fitting it into an upgraded Viper.
The spooled ten-pot is tipped to produce around 800 hp and 650 lb-ft of torque. More than that and the Viper's drivetrain, chassis and bodywork would have to be substantially reworked. Though beefier transmissions are available, fitting them would reportedly set off a domino-game of changes required to handle the added torque. Which may be something Chrysler would be prepared to do for the next-generation model, but in the meantime, 800 hp could prove enough to put the Viper back atop the Mopar performance ladder where it belongs, and give it an edge against the new Corvette Z06 to rekindle sales.

Roadkill builds crazy-cheap 1968 Dodge Charger rat rod using an old motorhome

Certain requests for description simply cannot be fulfilled, like if someone asked you to describe Picasso's Guernica or Gilliam's Brazil. There is only one appropriate answer to such entreaties, and that is: "You just gotta see it." That's where we are with the latest episode of Roadkill, wherein Messr's Freiburger and Finnegan dig out a 1968 Dodge Charger that Freiburger acquired in exchange for a set of cylinder heads, and intend to stuff it with the big-block motor from a long-bed, three-quarter ton Dodge pickup.
Only the pickup is too nice to tear apart, and the Charger needs a whole lot more lovin' - and parts - than initially expected. Enter, stage right, the Class A Dodge Pace Arrow motorhome with a 440 big-block purchased for $1,000, and a retired Plymouth Fury from a previous episode.
What ensues over the course of the 40-minute installment is more cuttin', yankin', leakin', stallin', hammerin' and smokin' action than you've seen in a long time, and some techniques that would have made even Cooter wonder, "I'm not sure if we should do that." By the end, though, the payoff is good enough to make you think about perusing AutoTrader for a '68 Charger just to see if maybe...