1998 Dodge Ram Van on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge celebrates centennial with Charger and Challenger 100th Anniversary Editions

In 1914, the Dodge brothers went from being a parts supplier to a full-scale automaker, and to celebrate the centennial of this milestone, Dodge will offer special editions of the 2014 Charger and Challenger early next year. Both cars will be sold in limited numbers (although no specific number was given), and these cars will stand out thanks to unique touches like 20-inch wheels, 100th anniversary edition logos and the exclusive High Octane Red Pearl Coat paint job (shown above).
The 100th Anniversary Edition package, which runs $2,200 on the 2014 Charger and $2,500 on the 2014 Challenger, comes with red or black leather seats with a cloud print (for a denim-like look) and metal badges on the seatbacks that read "Dodge Est. 1914," while similar logos are also found on the wheel center caps and front fenders. The instrument gauges are unique to each car, with the Charger getting black gauges and the Challenger getting white gauges, and to enunciate the 100-year anniversary, both cars have red numerals on the speedometer for the 100-mile-per-hour mark.
Finishing off the 100th Anniversary Edition cars, which will be offered on V6 and R/T models, Dodge adds a flat-bottom steering wheel and embroidered floor mats as a part of the package. Scroll down for the full press release for these commemorative models.

Roadkill builds crazy-cheap 1968 Dodge Charger rat rod using an old motorhome

Certain requests for description simply cannot be fulfilled, like if someone asked you to describe Picasso's Guernica or Gilliam's Brazil. There is only one appropriate answer to such entreaties, and that is: "You just gotta see it." That's where we are with the latest episode of Roadkill, wherein Messr's Freiburger and Finnegan dig out a 1968 Dodge Charger that Freiburger acquired in exchange for a set of cylinder heads, and intend to stuff it with the big-block motor from a long-bed, three-quarter ton Dodge pickup.
Only the pickup is too nice to tear apart, and the Charger needs a whole lot more lovin' - and parts - than initially expected. Enter, stage right, the Class A Dodge Pace Arrow motorhome with a 440 big-block purchased for $1,000, and a retired Plymouth Fury from a previous episode.
What ensues over the course of the 40-minute installment is more cuttin', yankin', leakin', stallin', hammerin' and smokin' action than you've seen in a long time, and some techniques that would have made even Cooter wonder, "I'm not sure if we should do that." By the end, though, the payoff is good enough to make you think about perusing AutoTrader for a '68 Charger just to see if maybe...