2010 Dodge Ram 3500 Diesel 4x4 Slt Hauler Crew Cab Texas Truck on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

NHTSA investigating 110,000 Ram 2500s and 3500s, one death alleged

The National Highway Traffic Safety Administration has launched an investigation focusing on 110,000 Dodge Ram 2500 and 3500 pickups from model years 2004 to 2006. One death has already been reported, according to NHTSA, due to a potential fault with the clutch interlocks on manual-transmission versions of the heavy duty pickup.
According to the report, these trucks can be started without depressing the clutch. There have been three reports so far, and as we mentioned above, one very sad incident seems to have resulted in the death of a child.
"One complaint involved an incident that occurred when a child was able to enter the vehicle and start the ignition without depressing the clutch. The vehicle then moved forward striking another child resulting in a fatality," NHTSA said in the investigation bulletin, which you can view below.

Mopar '13 Dart will roll into Chicago next week

We think this officially counts as a tradition. Every year going back to 2010, Mopar has rolled out a limited edition version of a popular product from the Chrysler Group portfolio. First it was the Mopar '10 Challenger, then the Mopar '11 Charger, then last year's Mopar '12 300, and this year it will be the Mopar '13 Dart, which will make its official world debut next week at the 2013 Chicago Auto Show.
Limited in number to just 500 units, the Mopar '13 Dart is no mere appearance package, though the demeanor of the Dart will be murdered out with a gloss black finish, gloss black 18-inch wheels, a set of Mopar blue stripes and a mean-looking Mopar ground effects kit. Likewise, the interior is touched up with leather seats (a blue one for the driver and black hides for the passengers), gloss black and black chrome trim, blue accent stitching, a sport pedal kit and other Mopar interior accessories.
Turning our attention back to the mechanical bits, the Mopar '13 Dart comes with the car's most powerful engine, a turbocharged 1.4-liter MultiAir four (shared with Fiat 500 Abarth) that's paired with a manual transmission. Those big, black wheels get wrapped in low profile 225/40R18 performance tires, and keeping everything in check is an upgraded brake kit with slotted rotors. The steering has also been calibrated for performance, the suspension lowered seven millimeters, and the exhaust tuned for better engine breathing.