2012 Dodge Ram Lone Star Crew Hemi Side Steps 20's 6k Texas Direct Auto on 2040-cars

Auto blog

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

Dodge Viper recall requires small-handed mechanics

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.

Jeep Grand Cherokee, Dodge Durango still catching fire after recall

Automakers issue recalls all the time. It's part of the cost of doing business. We just assume that once the recall has been carried out, the problem in question has been fixed. But that's not always the case, as this latest investigation being undertaken by the National Highway Traffic Safety Administration goes to show. The problem stems back to a recall issued by Chrysler last summer. It revolved rather the sun visor in the SUVs it makes at its Jefferson North Assembly Plant – specifically, the screw affixing the sun visor could end up rubbing against the wiring for the lamp in the vanity mirror, potentially causing an electrical short and even a fire. 62 such short circuits, 38 fires and three injuries reported, prompting Chrysler to recall nearly 900,000 units of the 2011-2014 Jeep Grand Cherokee and Dodge Durango (over 650,000 of them in the United States). The plastic spacers they installed to rectify the problem, however, may not have done the trick. Eight reports (but none involving injuries) have been filed with the NHTSA regarding the same issue recurring, spurring the government agency to open a new investigation into the matter. If deemed necessary, the NHTSA could ask FCA to issue another recall to fix the issue again, which we may necessitate the installation of a fuze to prevent any such the electric short. Related Video: INVESTIGATION Subject : Headliner Fires Date Investigation Opened: MAY 01, 2015 Date Investigation Closed: Open NHTSA Action Number: RQ15003 Component(s): ELECTRICAL SYSTEM , INTERIOR LIGHTING Manufacturer: Chrysler (FCA US LLC) SUMMARY: On July 1st, 2014 Chrysler (FCA US LLC) issued safety recall 14V-391 to remedy a wiring-related fire hazard on the headliner of approximately 661,888 model year (MY) 2011-2014 Jeep Grand Cherokee and Dodge Durango vehicles manufactured between January 5, 2010 and December 11, 2013. The recall was in response to the Office of Defects Investigation (ODI) investigation EA14-001 during which data provided by Chrysler indicates that the fire is caused by an electrical short in the vanity lamp wiring for either one of the sun visors mounted on the vehicle. The sun visors are mounted to the roof of the vehicle through the headliner with three metal screws.