2010 Dodge Ram 1500 Laramie on 2040-cars

Auto blog

MotorWeek remembers a better time for Mitsubishi performance

Dodge still knows how to create an capable performance car – look at the Hellcats, for example – but the same isn't true for Mitsubishi. With the Lancer Evo's demise, we don't expect driving enthusiasts to clamor for any of the Japanese automaker's other products. Things used to be different, though. As MotorWeek found in its new Retro Review, the 1991 Mitsubishi 3000GT VR4 and its sibling, the Dodge Stealth R/T Turbo, were impressive sports coupes in their day. Dodge and Mitsubishi packed a bevy of cutting-edge tech into the coupes. In these trims, both sported all-wheel drive, four-wheel steering, an adjustable suspension, active exhaust, and automatic climate control. The 3000GT VR4 upped the ante even more with active aero parts at the front and rear. Their 3.0-liter twin-turbo V6 was good for 300 horsepower and 307 pound-feet, which were good numbers at the time. This pair put all their gizmos to good use, too. MotorWeek compares the all-wheel-drive system's grip levels to a Porsche 911 Carrera 4. When was the last time you heard any favorable similarity between a Mitsubishi and a Porsche? The Stealth R/T Turbo and 3000GT VR4 came from a special time for Japanese sports coupes, when every brand had a halo model. Whether you were looking at Nissan 300ZX, Mazda RX-7, Toyota Supra, or even the Acura NSX, there was a lot to like on the market. MotorWeek's latest Retro Review offers a great reminder of that period.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.