2004 Dodge Ram 1500 Slt Crew Cab Pickup 4-door 5.7hemi on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Takata adds millions to recall expansion in US [UPDATE]

UPDATE: Ford spokesperson Kelli Felker has advised Autoblog that of the 1,509,535 total vehicles worldwide that the company is recalling, 966,504 of them are new additions for this expanded safety campaign. Last week, the National Highway Traffic Safety Administration announced that the Takata airbag inflator recalls would expand to an estimated 33.8 million vehicles in the US. However at the time, automakers weren't sure specifically which of their models might be affected under this enlarged campaign. Now, the numbers for BMW, FCA, Ford, and Mitsubishi are being released by the agency. Additionally, Honda is outlining the broadening of its own campaign. BMW's recall amounts to 420,661 vehicles in the US, an increase from 140,696 previously. All of the following models need their front, driver's side airbag replaced: 2002-2005 BMW 325i/325xi/330i/330xi Sedan 2002-2005 BMW 325xi/325i Sportswagon 2002-2006 BMW 330Ci/325Ci/M3 Convertible 2002-2006 BMW 325i/330i/M3 Coupe 2002-2003 BMW M5/540i/525i/530i Sedan 2002-2003 BMW 540i/525i Sportswagon 2003-2004 BMW X5 3.0i/4.4i BMW has received no reports of any injures or deaths from this problem in its vehicles. FCA has 5,224,845 vehicles globally in need of inflator replacements, according to its statement. However, the company is only aware of one injury related to the issue, which occurred in a 2006 Dodge Charger in southern Florida. There are 4,747,202 vehicles worldwide from the company that are affected on the front, driver's side. Among these, 4,066,732 are in the US, 374,508 are in Canada, and the rest are in other countries. The models are: 2005-2009 Dodge Ram 2500 Pickup 2004-2008 Dodge Ram 1500 Pickup 2006-2009 Dodge Ram 3500 Pickup 2007-2009 Dodge Ram 3500 Cab Chassis 2008-2010 Dodge Ram 4500/5500 Cab Chassis 2008-2009 Sterling 4500/5500 Cab Chassis 2004-2008 Dodge Durango 2007-2008 Chrysler Aspen 2005-2010 Chrysler 300/300C/SRT8 2005-2010 Dodge Charger/Magnum 2005-2011 Dodge Dakota 2006-2010 Mitsubishi Raider Also, there are 438,156 vehicles in the US, according to the NHTSA documents, that need their front passenger's side inflators replaced in the expansion of an earlier regional recall: 2003 Dodge Ram 1500 2003 Dodge Ram 2500 2003 Dodge Ram 3500 The total number of vehicles from Ford now covered under these campaigns stands at 1,509,535 worldwide. Of this total, there are 1,380,604 in the United States, 93,207 in Canada and 16,953 in Mexico.

Barracuda's Dodge branding no biggie, but what about engines?

Rumors about a revival of the Barracuda nameplate have been circulating for years now, though which brand it might fall under has been a bit of a mystery. Initial speculation had the car labeled an SRT product, but that acronym has since returned to its former role as a sub-brand for top-performance Mopars. Thanks to leaks from a recent FCA dealership event, we know the Barracuda is back on the table but will be sold under the Dodge umbrella, a move that has been generating a bit of ire from Pentastar fanatics, as the car was originally part of the defunct Plymouth brand. Given what's known about the new model, however, the badge is the least of my concerns about the new car. Let's start with the re-branding itself. This isn't the first time Chrysler has shuffled models around to different brands. The current-generation Viper spent two years as the flagship model under the SRT banner, only to return to Dodge for 2015 when SRT resumed its former role as a sub-brand. Years ago, the Neon was sold as a Plymouth, a Dodge, and a Chrysler model, depending on where you shopped for one. When Plymouth ceased to exist, the last few years of Prowler production got Chrysler badges instead. Then there's the new Jeep Renegade, a model whose name was born out of a trim level. The Barracuda might not turn out to be a muscle car in the way we currently define them. Further examples of naming liberties taken throughout automotive history could fill a book, but suffice it to say that these days a model's name has very little to do with the vehicle itself or any legacy it might have. The Barracuda name might be a particularly sacred cow with enthusiasts, but to me, a much bigger concern is the fact that the car might not turn out to be a muscle car in the way we currently define them. News from the Fiat Chrysler dealer briefing earlier this week indicates that when the next Charger debuts it will share its platform with the Barracuda, much the way the Charger and Challenger are twinned now. One difference is that the Barracuda is tipped to be offered as a convertible, while the modern Challenger is tintop-only. The Charger and Barracuda will use the rear-drive platform developed for Alfa Romeo's new Giulia, itself designed as a BMW M3 fighter both from a dimensional and dynamic standpoint; the Barracuda is expected to be slightly smaller than the current Challenger.