Miliatary 1942 Dodge Power Wagon C1 on 2040-cars

Auto blog

Dodge revives Challenger T/A and Charger Daytona trims for 2017

Dodge is reviving the Challenger's T/A trim and the Charger's Daytona line for 2017. Introduced on iconic Woodward Avenue just days before the annual Woodward Dream Cruise kicks off, the new variants promise more performance hardware and sportier aesthetics. We'll start with the two-door. The Challenger T/A, available with either the R/T trim's 5.7-liter V8 or the fire-breathing 6.4-liter Hemi V8, is inspired by the Challenger T/As of old. That means a less restrictive, 2.75-inch active exhaust system and a conical Mopar air filter. But there's no clear bump in output – Dodge still lists the base 5.7-liter at 375 horsepower and the 6.4-liter model at 485 hp. But hey, they're going to look cooler. Unlike the Challenger Hellcat, which should have it as standard, Dodge is including a Satin Black hood on every Challenger T/A. In fact, Satin Black is a recurring theme on this Challenger's front fascia, roof, rear decklid, and T/A bodyside stripes. And yes, the 20-inch Mopar wheels are black, too – they're also an inch wider than normal. Dodge is offering the T/A in three different trims. The base T/A has everything we described above, while the T/A Plus adds some comfort features like heated and vented Nappa leather seats, an 8.4-inch UConnect system with Apple CarPlay/Android Auto, a six-speaker stereo, and a shortcut button for the Dodge Performance Pages. The T/A 392, meanwhile, adds the 6.4-liter V8, even wider wheels, and Brembo six-pot calipers. If you prefer smoking tires with four doors, there's the new Charger Daytona. No, there's not an enormous wing on the back. But Dodge added the same kind of engine/exhaust upgrades found on the T/A while upping the top speed from 135 to 150 miles per hour. Satin Black features prominently again, with hood and rear fender graphics. The roof is also black. Unlike the Challenger, Dodge is only offering two different versions of the Daytona – the 5.7-liter base model and the 6.4-liter version, called the Daytona 392. Prices for the Challenger T/A start at $38,485, including a $1,095-destination charge, while the T/A Plus adds $2,750. Adding the 392 means shelling out $45,090. For the Daytona, you'll need a check for $40,985 for the 5.7-liter or $46,090 for the 6.4-liter. Orders for the Charger Daytona open in September, while the T/A is a month later. Related Video:

Cars.com runs 11-second quarter with Dodge Charger Hellcat

The Dodge Charger SRT Hellcat and its Challenger sibling are two of the heroes of the modern performance world. With a headline-grabbing 707 horsepower from a supercharged 6.2-liter V8, their output even shames many supercars. But how quick can one really cover a quarter mile? Cars.com recently decided to find out by taking a Charger Hellcat to the drag strip to see if the sedan lived up to Dodge's 11-second claims. The results were quite impressive. After 13 quarter-mile runs of adjusting variables like the tire pressures and the car's various electronic aids, the Charger Hellcat managed a pass in 11.03 seconds at 126.61 mph – the pinnacle result of the day. This car was mechanically stock and wore the optional Pirelli P Zero tires. According to Cars.com, other quick sprints reached 11.09 seconds and 11.1 seconds, which even beat the site's 11.41-second best from a Challenger Hellcat last year. Getting the Hellcat's prodigious power down without losing traction was a challenge, even on the summer tires. Cars.com thought it had a run that could have dropped below 11 seconds, but then the wheels spun. Using the factory-recommended pressures, the Charger Hellcat was no still slouch with an 11.27-second time recorded, but taking things down to 25 psi proved the quickest at the strip. We already knew that the Charger Hellcat was a wonderful vehicle for eating up huge gulps of asphalt at high speeds and could verify its 204-mile-per-hour top speed (quite a bit faster, incidentally, than the Ferrari California T's 196 mph top-speed). Apparently, the 11-second quarter-mile claim is just as accurate. Also, for any curious owners, the Cars.com story divulges many of the tweaks required to reach this seriously quick time. Related Video:

Dodge Charger to slim down and run turbo four in next generation

The current Dodge Charger is getting long in the tooth. It was originally introduced in 2005 as a 2006 model. In car terms, that's an eternity, though it's been refreshed twice. Still, FCA US will keep the LX-generation car going, reportedly facelifting it one last time for 2019. After that, there are some bigger changes in store . Automotive News is reporting that the follower to the current LX Charger will lose almost 500 pounds and will once again offer a turbo four-cylinder. You might remember the front-wheel-drive four-banger Charger of the early '80s. The recharged sedan will be twin-turbo and it's going to use the 300-horsepower four-cylinder engine currently under development for the 2018 Jeep Wrangler, AN says. The target weight for the future car is around 3,500 lbs, while the current car has a curb weight of nearly 4,000 lbs. Look for it to arrive in the early 2020s. The new platform will have a touch of Italian flair instead of the Daimler-Benz flavor embedded deep inside the LX cars. It will be built on an extended version of the 2017 Alfa Romeo Giulia's "Giorgio" platform, according to AN. Dealers were already shown a styling-buck almost a year ago. Related News: Featured Gallery 2015 Dodge Charger R/T View 42 Photos News Source: Automotive NewsImage Credit: AOL Alfa Romeo Dodge Future Vehicles Sedan FCA