1938 Dodge 1 1/2 Ton Custom Pickup 300hp on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge Viper recall requires small-handed mechanics

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.

Man hits 153 mph on I-75 in Dodge Magnum

A man driving in Michigan took his 2005 Dodge Magnum practically to the limit in the wee hours of the morning on May 19 when the Michigan State Police caught him on radar going 153 miles per hour on Interstate 75 near Detroit. The 21-year-old driver was spotted around 3:00 AM, according to The Detroit News. Michigan State Police First Lieutenant Michael Shaw told Autoblog that officers initially saw the man on radar doing 79 mph in a 70-mph-zone, and they started following him. He eventually clocked 153 mph. However, First Lt. Shaw was clear that there was never a pursuit. "Speeding isn't necessarily a reason to put the public at risk," he said. The situation ended rather abruptly, though. The driver pulled off the interstate and behind a building. He remained in the vehicle, and police arrived and arrested him. According to First Lt. Shaw, the man was driving home from work and alcohol wasn't a factor. The Magnum has been impounded, and the driver was charged with reckless driving. Unfortunately, First Lt. Shaw said that he didn't know what engine was in the wagon, but as enthusiasts, we're curious. After all, the 2005 Magnum RT was governed to 130 mph and the SRT8 wasn't unleashed until 2006, which means either the wagon must've been derestricted to hit such high speeds or that police have the year wrong. We'll let you know if we figure that one out...