2006 Dodge Magnum Wagon Silver 6 Cyl Automatic Cd Clean Title Runs Good on 2040-cars

Auto blog

2014 Dodge Journey Crossroad

Watchers of the auto industry will notice a theme among the formerly bankrupted American automakers, General Motors and Chrysler. There are the post-bankruptcy vehicles, and the pre-bankruptcy vehicles. The former, in the case of Chrysler, include the Jeep Grand Cherokee, as well as the 200 and 300. For GM, there's the Cadillac ATS, Chevrolet Impala and Buick Encore, among others. These vehicles have the freshest styling, with sharp exteriors and well-crafted interiors, as well as advanced powertrains and well-sorted chassis.
As for the pre-bankruptcy vehicles, they tend to be easy to spot. Most suffer from inferior driving dynamics, cheaper interiors, poorer fuel economy and often homely looks (we know, there were some decent cars before the bankruptcy, but they were pretty heavily outweighed by the bad ones). Think late, last-generation Chevrolet Impala or Chrysler 200. Increasingly, though, we're seeing vehicles that split the balance between pre- and post-bankruptcy. Vehicles like the Dodge Journey.
The Journey debuted in 2007 as a 2008 model year vehicle, meaning it should fall into the latter category. But heavily breathed upon in 2011, it now enjoys a new, 3.6-liter Pentastar V6, a big, critically acclaimed touchscreen display and in the case of today's tester, a new-for-2014 Crossroad spec.

Dodge Viper GTS-R goes back to old-school livery

The Dodge Viper may have been around now for over 20 years, but as far as racing achievements go, 2000 was its finest season. That's when it won the Rolex 24 at Daytona, the GTS class trophy at the 24 Hours of Le Mans and its second consecutive title in the American Le Mans Series.
Since then, SRT Motorsports hasn't quite had the same success, withdrawing from Le Mans this year and shedding the Dodge name and its emblematic red and white livery for the SRT badge and a silver snakeskin theme. But now that the Viper is back under the Dodge banner, so too is the racing team returning to its classic livery.
Starting from the six-hour race at Watkins Glen next week, both the No. 91 and No. 93 Viper GTS-Rs will wear the red base color with twin white racing stripes that its more accomplished forebears wore on circuits around the world. And with it, maybe the Viper will return once again to the winner's circle at home and abroad.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.