2002 Dodge Intrepid Se Sedan 4-door 2.7l on 2040-cars

Auto blog

Mopar '13 Dart priced from $25,485*

For the past few years, Chrysler's Mopar in-house tuning division has created its own one-off versions of several cars in the automaker's portfolio, including the Mopar '10 Challenger, Mopar '11 Charger and Mopar '12 300. For 2013, the black-and-blue up-do has been given to the new Dart compact, and Chrysler has announced that the limited-edition sedan is now available for order, priced from $25,485, not including *$995 for destination.
Like previous Mopar edition vehicles, the Dart is painted in a signature Pitch Black exterior with an offset blue racing stripe. The sedan sits seven millimeters lower to the ground and gets visual add-ons like a chin spoiler, decklid spoiler and rear diffuser, along with gloss black 18-inch alloy wheels.
Performance wise, the Dart's 1.4-liter MultiAir inline four-cylinder engine remains, producing 160 horsepower and 184 pound-feet of torque, mated to a six-speed manual transmission. The Mopar car gets a sport-tuned exhaust system along with revised power steering calibration and beefier brakes.

VW scandal, Alan Taylor on Vipers, and future cars | Autoblog Podcast #474

Episode #473 of the Autoblog Podcast is here. This week, Dan Roth chats with Sam Abuelsamid of Navigant Research about the just-announced deal pending between Volkswagen and the EPA, and Navigant's Transportation Outlook for 2025 to 2050. Alan Taylor, host of The Drive on ERN also visits the Podcast to talk about picking up his Viper ACR in Texas and driving it back to the West Coast. It all starts with the Autoblog Garage - check it out! Check out the rundown with times for topics, and thanks for listening! Autoblog Podcast #474 Topics VW/EPA deal Navigant Research Transportation Outlook Alan Taylor In The Autoblog Garage 2016 Lincoln MKX 2016 Volvo XC90 2016 Jeep Renegade Trailhawk Hosts: Dan Roth Guests: Sam Abuelsamid, Alan Taylor Rundown Intro & Garage - 00:00 VW/EPA - 25:51 Navigant Outlook - 38:47 Alan Taylor - 54:43 Total Duration: 01:13:11 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Feedback Email – Podcast at Autoblog dot com Review the show in iTunes Podcasts Dodge Volkswagen

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.