2014 Dodge Durango R/t Awd on 2040-cars

Auto blog

2013-14 Dodge Viper recalled over faulty door handles

The 2013-14 Dodge Viper is getting a voluntary recall affecting 1,762 cars worldwide to replace their door-handle assemblies. Of the affected vehicles, FCA US reports there are 1,451 in the US, 160 in Canada, 17 in Mexico and 59 of them outside of NAFTA. After receiving three reports of doors either not closing or opening while driving a low speeds, FCA US engineers found a new sealant from a supplier didn't provide sufficient moisture protection to the electronic switches for the door latches. If the parts get wet, this can potentially cause a short circuit. The automaker is quite clear that are no reports of accidents of injuries from this problem. As always, the recall repairs will be done at no cost to owners, and FCA US will be getting in touch with customers soon about the problem. Related Video: Statement: Door-handle Assemblies April 9, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 1,762 cars globally to replace their door-handle assemblies. FCA US launched an investigation after the Company received three warranty claims linked to doors that failed to close or opened inadvertently while vehicles were moving at low speed. The Company is unaware of any related injuries or accidents. Engineers determined a sealant, newly adopted by a supplier, provided inconsistent moisture protection to the electronic switches that control the door latches. Switches exposed to moisture may short-circuit. Affected are approximately 1,451 model-year 2013-14 Dodge Viper SRT cars in the U.S.; 160 in Canada; 17 in Mexico and 59 outside the NAFTA region. Affected customers will be notified and advised when they may schedule service, which will be performed at no cost. Customers with questions may call the FCA US Customer Information Center at 1-800-853-1403.

FCA recalling 63k Jeeps, Vipers and Ram ProMaster City vans

Fiat Chrysler Automobiles has announced a pair of recalls cover nearly 63,000 vehicles. The bigger of the two actions covers manual-transmission-equipped vehicles from 2006, including the Jeep Liberty and Wrangler, as well as the Dodge Viper. FCA engineers uncovered that the clutch ignition interlock switches use a kind of wire that was part of a previous recall campaign. Because of this, the company said that affected vehicles may not start, although in rare cases, "if recommended starting procedures are not followed," the affected vehicles may lurch forward after turning the key. Those recommended starting procedures "include activating the parking brake, placing the shift lever in neutral and pressing the clutch pedal before turning the vehicle's ignition key." Recall number two affects the company's 2015 Ram ProMaster City cargo and passenger vans. Owners will need to report to dealers to have a piece of tape removed from the side-curtain airbags. The tape is added during assembly and in some cases, may not have been removed. That could prevent the airbags from deploying in the event of a crash. Just under 59,000 vehicles are included in the first recall, including 43,874 in the United States, 11,309 outside of North America, 2,944 in Canada and 706 in Mexico. The ProMaster City recall includes just over 3,900 vehicles. FCA claims it's unaware of any injuries, fatalities or accidents related to either recall and will perform repairs free of charge. Scroll down for the official press release on both campaigns. Related Video: Statement: Clutch Ignition Interlock Switch April 23, 2015 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary recall of an estimated 43,874 older-model U.S.-market cars and SUVs equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. The action follows an investigation by FCA US engineers that discovered these vehicles are equipped with switches that contain a certain type of wire implicated in a previous campaign. The wire, which was temporarily substituted by a supplier for the specified material, may break. As a result, the vehicles may not start, and in rare cases – if recommended starting procedures are not followed – a vehicle may exhibit unintended movement when its ignition key is turned. FCA US is unaware of aware of any related injuries or accidents involving this population of vehicles.

FCA inline-six rumored to be real, headed for Jeep Wagoneer

In September, Allpar reported that that clues being dropped at Fiat- Chrysler headquarters, in the carmaker's factories, and on engineer resumes pointed to the development of an inline six-cylinder engine. The site has just proclaimed the rumor is reality, writing that the straight-six, "turbocharged to meet or beat 5.7 Hemi power ratings, with a smoother torque curve, is on the way." The motor's first outing is expected to be either the next-generation Jeep Grand Cherokee, debuting perhaps next year, or the Jeep Wagoneer, debuting in 2020 or 2021. "Tornado" is the purported codename for the power plant said to be just under three liters in displacement, expanding the family begun with the Global Medium Engine 2.0-liter turbo codenamed Hurricane. Engine bay constraints and a long use horizon mean engineers won't simply add two more cylinders to the GME, however. Allpar says the brief is to keep the Tornado GME-T6 — the alphanumeric for "turbocharged six" — no more than three inches longer than the Tigershark 2.4-liter four-cylinder. That means "major design changes" that could include a space-saving head, more closely spaced cylinders, and no cylinder liners. An FCA division called Comau could be called on for its "SmartSpray" plasma lining technology. Allpar muses that the standard version of the engine for Chrysler, Dodge, Jeep, and Ram could get a single twin-scroll turbocharger. Performance trims for Alfa Romeo and Maserati could get different heads and maybe twin turbos, an SRT version might also get both those tweaks. History shows that the Italian versions would make changes to the block, as well. Even so, the Tornado would be less expensive than any Ferrari-supplied V6. A straight-six would put FCA in company with current adopters BMW and Mercedes-Benz, future users like Jaguar, and perhaps Aston Martin. The engine would span the widest range of use cases in the U.S. carmaker's portfolio, though. Potential applications include being a base engine for Ram trucks, serving double duty as a base engine and 5.7-liter Hemi replacement for the Dodge Charger and Challenger, working in the high-end Jeeps, and as a properly hot trim — with Ferrari-designed heads — in the luxury Italian sports cars. The Alfa Romeo Giulia begs for just such motivation to fill the gap between the 280-hp, $42,695 Ti Sport RWD and the 505-hp, $73,700 Giulia Quadrifoglio RWD. And a twin-turbo inline-six in a Maserati Alfieri would stack up nicely with the Germans.