2003 Dodge Durango 2wd Auto 130k Miles Great Looking, Running & Driving Suv on 2040-cars

Auto blog

What is the fastest car in the world in 2024?

It wasn't that long ago that the notion of reaching 200 miles per hour in a car, on a road, seemed basically impossible. As you likely know by now, that time has passed. And once that threshold was crossed, the automotive world immediately began eying the next triple-digit benchmark: 300 miles per hour. It may have taken a little while, but the 300-mph line has been crossed, and some cars have moved well past that seemingly insane speed number. While some of these speeds have been achieved in simulations (including the fastest car listed below), there's little doubt that a driver with nerves of steel and a heavy right foot could indeed push several automobiles up to 300 miles per hour and beyond. Interestingly, it’s not just one car or automaker in the 300-mph club, as a handful of models have earned a place (sometimes claimed but not yet demonstrated) on the leaderboard. The fastest car in the world is: Koenigsegg Jesko Absolut (330 MPH) That title goes to the Koenigsegg Jesko Absolut, which recorded a staggering 330 mph top speed earlier in 2023. The carÂ’s twin-turbocharged 5.0-liter V8 lays down 1,600 horsepower and 1,106 pound-feet of torque, which plays a significant role in delivering that speed, but KoenigseggÂ’s engineers have given the car a lot more than mind-blowing power. The Jesko Absolut has a super-slippery 0.278 drag coefficient and a nine-speed transmission that shifts so quickly itÂ’s almost imperceptible. Koenigsegg calls it a Light Speed Transmission (LST), saying its shifts happen at almost light speed. While that might be a slight exaggeration, the gearbox is impressive, bringing several wet multi-disc clutches and a super lightweight construction. As Koenigsegg says, "the Jesko Absolut is destined to achieve higher, more extraordinary speeds than any Koenigsegg or any other fully homologated car before it." How expensive is the Koenigsegg Jesko Absolut? If you were reading that and wondering how much the fastest car in the world costs, the price tag is just another dizzying number on the Jesko Absolut's spec sheet. All 125 Absolut cars offered sold out at a price of almost $3 million. Of course, being able to afford the Koenigsegg is just the first step in realizing its full potential. There are very few places on the map that can support a 300-plus-mph speed run, and the locations that do are not conveniently located.

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

Dodge Scat Pack for 5.7L Hemi V8 detailed, priced

Dodge revived the Scat Pack name back in November at the 2013 SEMA show. At the time, though, we were short of details on forthcoming upgrade packages, which were destined to add some oomph to the Challenger, Charger and Dart. We're still waiting to hear about the upgrades to the Dart's 2.4-liter four-pot, but Dodge has gone ahead and released the details on the upgrades to the 5.7-liter Hemi V8 in the Challenger and Charger R/T.
As we detailed in our original post, three different Scat Packs will be available that will allow customers to upgrade their cars without voiding the warranties. Starting with the $2,195 Stage 1 kit, owners will net an extra 18 horsepower and 18 pound-feet of torque thanks to a Mopar-branded cold-air intake, exhaust and ECU ref lash. Stage 1 is also the only package that could be installed outside of a Chrysler-authorized service center without voiding the warranty (a mechanically competent owner could even do it at home, we're told by Dodge). Stage 2 builds on the entry level Scat Pack, and adds performance camshaft kit, which boosts output over the stock 5.7 by up to 30 hp for $1,895. As with the Stage 1, the ECU is tweaked.
For those that want to go whole hog, they can add the Stage 3 for $4,995. The top-tier gets quite serious, adding CNC-ported cylinder heads, as well as high-flow headers and cats. Output over stock is 58 hp and 47 lb-ft of torque. Each kit comes with a pair of badges, just in case owners want a bit of visual flair.