Find or Sell Used Cars, Trucks, and SUVs in USA

1974 Dodge Dart Sport 440 4-speed on 2040-cars

Year:1974 Mileage:899 Color: Blue /
 Tan
Location:

San Mateo, California, United States

San Mateo, California, United States
Transmission:4-Speed manual
Body Type:Two door
Engine:440
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
Condition:
Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ...
VIN (Vehicle Identification Number)
: LL29C4G263386
Year: 1974
Interior Color: Tan
Make: Dodge
Number of Cylinders: 8
Model: Dart
Trim: Dart Sport
Drive Type: Fast
Mileage: 899
Exterior Color: Blue
Warranty: Vehicle does NOT have an existing warranty

Up for auction is a 1974 Dodge Dart Sport, I bough this car from the original owner in Eugene Oregon and drove it to California. The car came original with a 225 slant six and a floor mounted 3-speed transmission. Over the years I replaced the drive train with a 1968 440 engine Dodge 4-speed and I even put in a Dana 60. The Engine,Transmission  and Rear End has been complete rebuilt. Installed power front disc brakes, Mopar Performance super stock springs and torsion bars the A-body big block K-member is a Direct Connection part. Their is less then 1000 miles on the drive train and brakes. The Engine has stock compression 10.25 the cam is the Purple Shaft Hemi grind (sounds great) high volume oil pump, windage tray high rise Mopar intake with a big Holley carb. Exhaust: TTI headers Turbo mufflers with turn downs. The Dana 60 has 3:54 power loc replaced all bearings and seals. Battery is mounted in the trunk, has manual steering, Mopar 15" wheels. Interior: Buckets seats new carpet all in great condition. The left door and fender I replaced because of rust spot, their is some small rust at lower 1/4 panel and also there was a 1/2 vinal top I removed, had small rust holes. I also have two hoods and other body panels. The car is very Fast! I have never abuse this car just like to feel the power of a 440.

 

 I will also consider a offer.

 

 

 

 


On Sep-25-13 at 16:18:31 PDT, seller added the following information:

 

Auto Services in California

Woody`s Auto Body and Paint ★★★★★

Automobile Body Repairing & Painting, Truck Body Repair & Painting
Address: 9020 Gardendale St, Santa-Fe-Springs
Phone: (562) 633-3813

Westside Auto Repair ★★★★★

Auto Repair & Service, Auto Oil & Lube, Brake Repair
Address: 115 McPherson St, Davenport
Phone: (831) 600-7074

West Coast Auto Body ★★★★★

Automobile Body Repairing & Painting, Truck Body Repair & Painting
Address: 15144 Valley Blvd, Cerritos
Phone: (626) 961-2779

Webb`s Auto & Truck ★★★★★

Auto Repair & Service
Address: 2146 S Atlantic Blvd, Bell-Gardens
Phone: (323) 268-1266

VRC Auto Repair ★★★★★

Auto Repair & Service
Address: 2409 Main St, Moreno-Valley
Phone: (951) 276-3280

Visions Automotive Glass ★★★★★

Auto Repair & Service, Glass-Auto, Plate, Window, Etc, Glass-Automobile, Plate, Window, Etc-Manufacturers
Address: 8698 Elk Grove Blvd #1-238, Walnut-Grove
Phone: (877) 312-0678

Auto blog

Fiat Chrysler expands Takata airbag recall to 3.3M vehicles

Fri, Dec 19 2014

Fiat Chrysler Automobiles is expanding its recall of vehicles equipped with Takata airbags, moving beyond Florida, Hawaii, Puerto Rico and the US Virgin Islands to the greater US, as well as Mexico, Canada and beyond. The affected vehicles, some 3.3 million in total, were built between 2004 and 2007, with many models, including the Dodge Ram 1500, 2500 and 3500, Durango and the Chrysler 300, having been affected by Chrysler's previous recall. Despite the somewhat alarming nature that comes with a recall of this many vehicles, it seems that Chrysler is moving more out of an abundance of caution (and federal pressure) than anything else, saying: "Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles." Owners of affected vehicles will be notified and asked to report to dealers for a free replacement driver's side airbag. Scroll down for the official press release from FCA. Statement: Global Air-Bag Inflator Replacement December 19, 2014 , Auburn Hills, Mich. - FCA US LLC will replace driver's-side air-bag inflators in an estimated 3.3 million older-model vehicles worldwide, in an expansion of an ongoing regional field action. Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles. Outside of Florida, one of the areas covered by the original action, no FCA US vehicle has been linked to an air-bag deployment of the type that has raised public concern. Nevertheless, the Company is replacing the Takata components tied to that concern. FCA US is aware of one related injury involving one of its vehicles, an older-model sedan. It occurred in a southern Florida region marked by persistent, high, absolute humidity – a condition believed to be a contributing factor in the air-bag deployments under investigation.

Dodge idles Viper production again at Conner Avenue

Mon, 07 Jul 2014

You've got to hand it to Dodge for having the gumption to put the original Viper into production in the first place. It was, after all, much more of an emotional decision than a practical one, and a move which saw the first production V10 engine placed in a road car - long before the advent of the Lamborghini Gallardo, Audi R8, Porsche Carrera GT or Lexus LFA, not to mention the other Ford, BMW and Volkswagen Group models that used such engines.
It's now been 22 years since the first Viper entered production and the Viper still rolls on several generations later, but we're sad to say that courageous decision has not always been met with overwhelming sales success. In fact parent Chrysler was forced to idle the Conner Avenue plant where the Viper is made back in April due to slow sales. And while production resumed again as planned on June 23, it apparently didn't do the trick.
As a result, Chrysler corporate communications chief Shawn Morgan revealed to Autoblog that the assembly line has been shut down again for another two weeks. The line was up and running for nearly two full work weeks from June 23 until the holiday weekend that started on Thursday, July 3. But instead of coming back online today as planned, it's been idled again for the weeks of July 7 and 14. That means it will be July 21, at the earliest, before the serpentine supercars start slithering down the assembly line at Conner Avenue again. Once it does, however, production is set to resume at the same pace it was before the shutdown.

Trump tells Detroit 3 CEOs he wants more US jobs, calls environmentalists 'out of control'

Tue, Jan 24 2017

As expected, President Donald J. Trump met with top executives from FCA, Ford, and General Motors this morning as part of a larger push to generate jobs in America. "I want new plants to be built here for cars sold here!", Trump said in a tweet ahead of the meeting. Not everything said in the meeting was made public, but the President later tweeted that he had a "Great meeting with automobile industry leaders." FCA CEO Sergio Marchionne, Ford chief Mark Fields, and GM's Mary Barra all echoed the positive vibes after the meeting. In a statement, Barra called the discussion "very constructive and wide-ranging," adding that it focused on "policies that support a strong and competitive economy and auto industry," and "that supports the environment and safety." That's noteworthy, because Trump is reported to have said "I am to a large extent an environmentalist. I believe in it, but it's out of control." Fields, speaking to reporters after the meeting, said, "We're excited about working together with the president and his administration on tax policies, on regulation and on trade to really create a renaissance in American manufacturing." The Ford CEO was specifically talking about Trump's withdraw from the Trans-Pacific Partnership. "We've repeatedly said that the mother of all trade barriers is currency manipulation, and TPP failed in meaningfully dealing with that, and we appreciate the president's courage to walk away from a bad trade deal," he said. Marchionne focused on American manufacturing in his statement after the meeting. "I appreciate the President's focus on making the US a great place to do business. We look forward to working with President Trump and members of Congress to strengthen American manufacturing." Perhaps equally as interesting as what was said and who was invited are what wasn't said and who wasn't invited. Trump has been very vocal about his distaste for US automakers' plants in Mexico, but no mention was made of the North American Free Trade Agreement by Trump or any of the Detroit CEOs after the meeting. We also have to wonder if Trump plans to meet with representatives from German, Japanese, and Korean automakers that have made massive investments into American plants and produce a large number of cars in this country. Related Video: News Source: Reuters, General Motors, Fiat Chrysler Automotive, Donald J.