1994 Dodge Dakota Sport Standard Cab Pickup 2-door 3.9l on 2040-cars

Auto blog

Chrysler's Jefferson North plant builds 5-millionth SUV [w/video]

Chrysler's Jefferson North Assembly Plant opened in 1992 for production of the first Jeep Grand Cherokee, but in the subsequent years, the Detroit plant has gone on to produce some of the company's biggest SUVs including the Jeep Commander and Dodge Durango. Earlier this week, the plant produced its five-millionth SUV, which, fittingly, was a Grand Cherokee.
Celebrating the plant's five-millionth unit, the silver 2014 Grand Cherokee was promptly donated to the USO. In addition to this milestone SUV, Chrysler also had a near-perfect 1993-95 ZJ Grand Cherokee on hand for the photo op. Scroll down for the Chrysler press release as well as a video showing some of the speeches from the celebration.

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.