1992 Dodge Dakota Le - 80k Original Miles ****no Reserve**** on 2040-cars

Auto blog

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.

Are supercars becoming less special?

There's little doubt that we are currently enjoying the golden age of automotive performance. Dozens of different models on sale today make over 500 horsepower, and seven boast output in excess of 700 hp. Not long ago, that kind of capability was exclusive to supercars – vehicles whose rarity, performance focus, and requisite expense made them aspirational objects of desire to us mortals. But more than that, supercars have historically offered a unique driving experience, one which was bespoke to a particular model and could not be replicated elsewhere. But in recent years, even the low-volume players have been forced to find the efficiencies and economies of scale that formerly hadn't been a concern for them, and in turn the concept of the supercar as a unique entity unto itself is fading fast. The blame doesn't fall on one particular manufacturer nor a specific production technique. Instead, it's a confluence of different factors that are chipping away at the distinction of these vehicles. It's not all bad news – Lamborghini's platform sharing with Audi for the Gallardo and the R8 yielded a raging bull that was more reliable and easier to live with on a day-to-day basis, and as a result it went on to become the best-selling Lambo in the company's history. But it also came at the cost of some of the Italian's exclusivity when eerily familiar sights and sounds suddenly became available wearing an Audi badge. Even low-volume players have been forced to find economies of scale. Much of this comes out of necessity, of course. Aston Martin's recent deal with Mercedes-AMG points toward German hardware going under the hood and into the cabin of the upcoming DB11, and it's safe to assume that this was not a decision made lightly by the Brits, as the brand has built a reputation for the bespoke craftsmanship of its vehicles. There's little doubt that the DB11 will be a fine automobile, but the move does jeopardize some of the characteristic "specialness" that Astons are known for. Yet the world is certainly better off with new Aston Martins spliced with DNA from Mercedes-AMG rather than no new Astons at all, and the costs of developing cutting-edge drivetrains and user interfaces is a burden that's becoming increasingly difficult for smaller manufacturers to bear. Even Ferrari is poised to make some dramatic changes in the way it designs cars.