1969 Dodge Coronet on 2040-cars

Auto blog

2018 Dodge Demon comes with a factory tune for race gas

We knew the Dodge Demon was going to make a lot of power, but the ongoing question has been how much. We've seen estimates of between 757 and 1,121, but those have simply been guesses based on the numbers found in promo photos. However, if we had to put our bets on a horsepower rating, we'll probably go with the higher estimates because the Demon can run on race gas. Yes, the latest teaser for the Demon reveals that it will come with a factory tune optimized for race gas, which is rated at 100 octane or higher. Running such high octane, in combination with its heavy-duty intake cooling, means the Demon can handle absurd amounts of boost and advanced timing without running the risk of dangerous pre-ignition or detonation. Of course this also means the Demon should be capable of astonishing power with the high-octane calibration. The tune will be included in the Demon crate on a separate engine computer that the owner can swap out when he or she is ready to race. In addition to the computer, the center stack also has a button to activate the high-octane mode. A pair of fuel pumps and larger injectors also ensure the engine gets plenty of that sweet racing fuel. When not running the high-octane tune, the Demon runs on your average premium gasoline. Also, in case you accidentally run premium gas with the high-octane mode activated, the car will automatically switch to the default tune if engine knock is detected. You can get a peek at the system in the video above, and be on the lookout for a bonus video tomorrow. The full reveal will be next week on April 11 at the New York auto show. Related Video:

Chrysler almost smothered the Hellcat before it lived

Chrysler's 6.2-liter supercharged Hellcat V8 was an absolute sensation from the very moment it was announced, and honestly, how could it not have been? Packing 707 horsepower and 650 pound-feet of torque, its numbers immediately put every other production muscle car (and many supercars) to shame. Plus, we soon learned that would be wrapped in a package retailing for around $60,000 - a pittance compared to other vehicles offering similar grunt. However, the Hellcat almost never got the chance to rumble under the hood of the Challenger and Charger.
The Hellcat was initially proposed back in 2011, back when Fiat was deciding its future strategy for Chrysler Group, according to Automotive News. At the time, the company was just emerging from its bankruptcy doldrums, and an ultra-high-performance V8 wasn't exactly a must-have item. The program didn't move forward. However, SRT engineers kept fighting, according to AN, and four months later, they received the green light to pull the project off the shelf and continue developing the Hellcat. The muscle car world is certainly better for that decision.
The work of those engineers focused on taking Chrysler's standard 6.2-liter V8 and making it reliably handle all of the extra power from the supercharger. "It came down to micron levels of changes in the crank to be able to withstand the pressures of the engine," said Chris Cowland, director of advanced and SRT powertrain, to Automotive News. The changes amounted to switching out about 91 percent of the parts to make the Hellcat, including some quite minuscule alterations. For example, the washer holding the supercharger pulley is embedded with industrial diamonds to keep it from slipping.

2013-14 Dodge Viper recalled over faulty door handles

The 2013-14 Dodge Viper is getting a voluntary recall affecting 1,762 cars worldwide to replace their door-handle assemblies. Of the affected vehicles, FCA US reports there are 1,451 in the US, 160 in Canada, 17 in Mexico and 59 of them outside of NAFTA. After receiving three reports of doors either not closing or opening while driving a low speeds, FCA US engineers found a new sealant from a supplier didn't provide sufficient moisture protection to the electronic switches for the door latches. If the parts get wet, this can potentially cause a short circuit. The automaker is quite clear that are no reports of accidents of injuries from this problem. As always, the recall repairs will be done at no cost to owners, and FCA US will be getting in touch with customers soon about the problem. Related Video: Statement: Door-handle Assemblies April 9, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 1,762 cars globally to replace their door-handle assemblies. FCA US launched an investigation after the Company received three warranty claims linked to doors that failed to close or opened inadvertently while vehicles were moving at low speed. The Company is unaware of any related injuries or accidents. Engineers determined a sealant, newly adopted by a supplier, provided inconsistent moisture protection to the electronic switches that control the door latches. Switches exposed to moisture may short-circuit. Affected are approximately 1,451 model-year 2013-14 Dodge Viper SRT cars in the U.S.; 160 in Canada; 17 in Mexico and 59 outside the NAFTA region. Affected customers will be notified and advised when they may schedule service, which will be performed at no cost. Customers with questions may call the FCA US Customer Information Center at 1-800-853-1403.