1968 Dodge Coronet 500 Hardtop 2-door 7.2l on 2040-cars

Auto blog

NHTSA is investigating FCA shifters for roll-away accidents again, this time the rotary units

It seems FCA's shifter troubles aren't over yet. Now, just a few months after issuing a recall to resolve user-related issues with its monostable shifters, the company is again under investigation by NHTSA. The issue is related to the potential for cars to roll away when the rotary-style shifter is not properly placed in park. Two FCA models are the subject of this investigation: the 2013–2016 Ram 1500 and the 2014–2016 Dodge Durango. NHTSA estimates about 1,000,000 vehicles would be affected if a recall is issued. The investigation was started following 43 complaints of vehicles rolling away while supposedly being in "park." Among the complaints were reports of 25 crashes and 9 injuries. NHTSA does point out that in every incident, the parking brake was not engaged. A representative from FCA also gave us an official statement regarding the investigation: "FCA US is cooperating fully with NHTSA's investigation, the scope of which is limited. Other vehicles equipped with rotary shifters are not included. In accordance with prudent practice, the Company joins NHTSA in urging all drivers to use their vehicles' parking brakes." View 35 Photos As mentioned above, other Chrysler products with rotary shifters, such as the Pacifica minivan and 200 sedan, are not involved in this investigation. One of the key differences, as the representative told us, is that these vehicles have electronic parking brakes that automatically engage if the driver does not select park and then opens the door with the seatbelt unbuckled. The Ram 1500 and Durango feature mechanical, manually operated parking brakes and therefore cannot activate the brake automatically. Because this is currently an investigation, an exact cause for the incidents has yet to be determined, and none of the vehicles have been recalled. It's possible there could be a mechanical defect. However, the issue could be a confusing interface causing user error, as was the case with FCA's monostable shifters, where drivers think they've put the car in park but actually haven't. Something that indicates it could be a case of confused users is that NHTSA also opened an investigation into 2012–2014 Jaguar XF and Land Rover Range Rover Evoques for similar issues. Both vehicles use a rotary shifter and have had roll-away complaints levied as well. Even if it is a case of user error, FCA and Jaguar Land Rover may still have to recall their vehicles.

Chop the top of your new Dodge Viper for $35,000

We have good news, and we have bad news. First, the good: It's now possible to get a brand-new Dodge Viper roadster, which is nice, considering we're in the dead of summer and many of us like wind-in-the-hair motoring. Now, the bad: This is not a factory option from the automaker, instead coming courtesy of an aftermarket company called Prefix Performance, and that means it's going to cost you some serious coin.
Called Medusa, this drop-top Viper was created without the knowledge or consent of Dodge, but that's probably fine because Prefix works with the automaker already for the final preparation of the American supercar, including paint. According to the company, the current, fifth-gen Viper was built with a convertible version in mind, so no chassis strengthening is required. From the looks of the somewhat grainy photos available, the conversion appears of very high quality.
Want one? Well, that means you're going to need to procure a Viper - Prefix has 10 units ready for transformation as it stands - and that's going to cost at the very least $102,485. Then, you'll need to write a check for an additional $35,000 for Prefix to surgically remove the car's roof. Thing is, for that kind of cash, a prospective owner could buy, among other very nice options, a Viper hardtop and a loaded Miata, or a Corvette Stingray convertible and several pockets full of change. Or, perhaps a new Viper hardtop and a used, first-gen Viper convertible?

Dodge Challenger Scat Pack adds power and noise, with a warranty

If you want to go fast, there's certainly nothing wrong with the Dodge Challenger SRT8. With 470 horsepower and 470 pound-feet of torque for 2014, there's certainly not much to complain about. But what if you want something more aftermarket in flavor? There's no shortage of options, but while turning to the tuner world will make your car plenty fast, that extra power won't just shred rear tires, it'll torch your warranty, as well. That's where Dodge's Scat Pack comes in.
With three stages of mods for both the 5.7 and 6.4-liter Hemi V8s Challenger (as well as the 5.7-liter Charger and, soon, the four-pot Dart), the Scat Pack cars give drivers all the power, aggression and noise of a heavily modded aftermarket car while maintaining the piece of mind provided by the Dodge warranty.
Power gets bumped up to 485 horsepower and 475 pound-feet of torque with the 6.4-liter Scat Pack, while the 5.7-liter can provide up to 58 hp and 47 lb-ft of torque to add to the stock engine's 375 horsepower and 410 pound-feet. It's the latter engine that can really get some work done, with upgrades ranging from the mundane - intake and exhaust - to the racy, like the ported heads and high-flow headers.