We Finance!!! 2010 Dodge Challenger Srt-8 Hemi Roof Nav Heated Seats Texas Auto on 2040-cars

Auto blog

2013-14 Dodge Viper recalled over faulty door handles

The 2013-14 Dodge Viper is getting a voluntary recall affecting 1,762 cars worldwide to replace their door-handle assemblies. Of the affected vehicles, FCA US reports there are 1,451 in the US, 160 in Canada, 17 in Mexico and 59 of them outside of NAFTA. After receiving three reports of doors either not closing or opening while driving a low speeds, FCA US engineers found a new sealant from a supplier didn't provide sufficient moisture protection to the electronic switches for the door latches. If the parts get wet, this can potentially cause a short circuit. The automaker is quite clear that are no reports of accidents of injuries from this problem. As always, the recall repairs will be done at no cost to owners, and FCA US will be getting in touch with customers soon about the problem. Related Video: Statement: Door-handle Assemblies April 9, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 1,762 cars globally to replace their door-handle assemblies. FCA US launched an investigation after the Company received three warranty claims linked to doors that failed to close or opened inadvertently while vehicles were moving at low speed. The Company is unaware of any related injuries or accidents. Engineers determined a sealant, newly adopted by a supplier, provided inconsistent moisture protection to the electronic switches that control the door latches. Switches exposed to moisture may short-circuit. Affected are approximately 1,451 model-year 2013-14 Dodge Viper SRT cars in the U.S.; 160 in Canada; 17 in Mexico and 59 outside the NAFTA region. Affected customers will be notified and advised when they may schedule service, which will be performed at no cost. Customers with questions may call the FCA US Customer Information Center at 1-800-853-1403.

2023 J.D. Power APEAL Study shows new-car customer satisfaction scores slip

J.D. Power survey results have been slightly up but mostly down for automakers this year, literally. In February, the 2023 Vehicle Dependability Study showed an overall decline compared the 2022 a month before the Customer Service Index Study did the same. The trend reversed in June with a better overall score on the 2023 U.S. Electric Vehicle Consideration Study than in 2022, then declined again the same month on with a lower overall score on the 2023 Initial Quality Study. The declines continue with the 2023 J.D. Power U.S. Automotive Performance, Execution and Layout (APEAL) Study, overall satisfaction among the 84,555 respondents down two points overall compared to 2022, to 845 out of 1,000 points. Because last year's score dropped compared to 2021, this year marks the first consecutive decline in the study's 28-year history. The study tries to "[measure] owners' emotional attachment and level of excitement with new vehicle" after 90 days of ownership by asking new owners to rate 37 attributes in 10 areas around the vehicle, such as the feeling they get when they hit the accelerator. Satisfaction with nine of the attributes is down this year versus last, fuel economy the only segment to show better results with 15 points more satisfaction. Styling and infotainment are big drags on satisfaction. Responses to new car exterior looks tallied 888 points, down from 894 last year, the largest drop in this year's study. On the digital side, less than half of those surveyed this year said they prefer using a manufacturer's built-in infotainment. From 70% of respondents in 2020 preferring to use a manufacturer's in-house software to play audio instead of Android Auto or Apple CarPlay, that's 56% in 2023. Going all-in on Google appears to have the best effect. J.D. Power said that vehicles with both Google's Android Automotive Operating System (AAOS) and Google Automotive Services (GAS) "score higher in the infotainment category than those with no AAOS whatsoever. AAOS without GAS receives the lowest scores for infotainment of the three categories."  Frank Hanley, senior director of auto benchmarking at J.D. Power, said, "Despite the technology and design innovations that manufacturers put into new vehicles, owners are lukewarm about them. While innovations like charging pads, vehicle apps and advanced audio features should enhance an owner’s experience, this is not the case when problems are experienced.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.