70 Convertible Challenger Hemi Rotisserie Restored on 2040-cars

Auto blog

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

Big rig gets blown over on Wyoming freeway, flattens police cruiser

A big rig navigating a stretch of windy Wyoming highway last week was blown over by high winds and landed on a Wyoming Highway Patrol cruiser. According to CBS News, three Wyoming Highway Patrol troopers responded to an accident along Interstate 80 near Elk Mountain on February 7. While the troopers were out of their cars assisting the crash victims, a white Volvo semi-truck lumbered up I-80 toward them. Wind gusts in that part of Wyoming were clocked in at up to 90 miles per hour on Tuesday, and one of them caught the semi as it neared the parked cruisers. Video from one of the cruiser's onboard cameras showed the big rig drift to the right as a big gust hit the trailer. Slowly, the whole rig tipped over and flattened one of the parked cruisers. The truck then slid a few feet on its side and came to a stop just aft of the cruiser. None of the troopers were injured in the incident, and two people in the truck came out of it unhurt as well. Patrol Lieutenant David Wagener told KGWN that that stretch of I-80 was closed on Tuesday to lightweight, high-profile vehicles. The truck driver was cited for the incident. High winds are no joke, and vehicles getting blown around or even clean off the road is a pretty common phenomenon. Way back in 2011, a truck got blown over in Utah. Then there was a train that got blown off a bridge in Louisiana in 2015. Related Video: News Source: CBS News, KGWN Auto News Dodge Volvo Driving Safety Truck Commercial Vehicles Police/Emergency Sedan semi truck rollover wyoming

Question of the Day: Most heinous act of badge engineering?

Badge engineering, in which one company slaps its emblems on another company's product and sells it, has a long history in the automotive industry. When Sears wanted to sell cars, a deal was made with Kaiser-Frazer and the Sears Allstate was born. Iranians wanted new cars in the 1960s, and the Rootes Group was happy to offer Hillman Hunters for sale as Iran Khodro Paykans. Sometimes, though, certain badge-engineered vehicles made sense only in the 26th hour of negotiations between companies. The Suzuki Equator, say, which was a puzzling rebadge job of the Nissan Frontier. How did that happen? My personal favorite what-the-heck-were-they-thinking example of badge engineering is the 1971-1973 Plymouth Cricket. Chrysler Europe, through its ownership of the Rootes Group, was able to ship over Hillman Avanger subcompacts for sale in the US market. This would have made sense... if Chrysler hadn't already been selling rebadged Mitsubishi Colt Galants (as Dodge Colts) and Simca 1100s as (Simca 1204s) in its American showrooms. Few bought the Cricket, despite its cheery ad campaign. So, what's the badge-engineered car you find most confounding? Chrysler Dodge Automakers Mitsubishi Nissan Suzuki Automotive History question of the day badge engineering question