1971 Dodge Challenger on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

NHTSA investigating 110,000 Ram 2500s and 3500s, one death alleged

The National Highway Traffic Safety Administration has launched an investigation focusing on 110,000 Dodge Ram 2500 and 3500 pickups from model years 2004 to 2006. One death has already been reported, according to NHTSA, due to a potential fault with the clutch interlocks on manual-transmission versions of the heavy duty pickup.
According to the report, these trucks can be started without depressing the clutch. There have been three reports so far, and as we mentioned above, one very sad incident seems to have resulted in the death of a child.
"One complaint involved an incident that occurred when a child was able to enter the vehicle and start the ignition without depressing the clutch. The vehicle then moved forward striking another child resulting in a fatality," NHTSA said in the investigation bulletin, which you can view below.

2003-04 Dodge Viper recalled for sudden airbag deployment

As if driving the old Dodge Viper (not the fancy new SRT model) isn't intimidating enough, imagine trying to wrangle that V10 beast and then suddenly having the airbags deploy. Yikes. That's apparently what could happen to some 3,660 Viper models from the 2003 and 2004 model years, and as such, Chrysler has issued a recall.
According to the National Highway Traffic Safety Administration, part of the car's airbag control module may fail, causing the bags or seatbelt pre-tensioners to deploy without warning while the vehicle is in operation. That's a dangerous scenario in any car, let alone one offering insane horsepower a near-total paucity of safety nannies should things get squirrely.
Owners will be notified this month about the recall, though a remedy is not expected to be available until later this year. Scroll down for the full NHTSA statement.