1970 Challenger on 2040-cars

Auto blog

Dodge Viper might not live past 2017

The Dodge Viper might be running out of venom because the muscle-bound sports car could be on the road to being cancelled in just a few years. According to Allpar, the proposed deal between the United Auto Workers and FCA US would close the Connor Avenue Assembly plant, which produces the Viper, in 2017. The proposed union contract doesn't give a reason for closing the factory, but the decision is understandable if frustrating. The plant was idled twice last year to reduce production of the Viper to match flagging demand. A $15,000 price cut for the coupe eventually allowed for a sales surge, but that appetite hasn't continued in 2015. From January through September of this year, the company has only moved 503 of the sports cars, down eight percent. To further spur demand, Dodge has employed a few other tactics like the 1 of 1 program for buyers to personalize their Vipers, and the introduction of the brutally track-focused ACR. In a world where high-end sports cars are continuing to get friendlier for both their drivers and the environment, the Viper remains a holdout with a big, naturally aspirated V10. Even with the addition of some electronic aids on the latest Vipers, the snake still demands respect from those behind the wheel. Respect is fine, but sales are what matter to FCA – and the harsh reality is that a lack thereof might force the Viper into retirement, whether we like it or not.

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

Dodge Viper returning to Le Mans this year?

If you were among the fans disappointed by Chrysler's recent decision to end the Dodge Viper's racing program, we may have some good news for you, as the racing outfit behind the campaign is reportedly working to bring the American supercars back to Le Mans this year. That racing outfit is Riley Technologies, a constructor perhaps best known for its Daytona Prototypes, but it has also prepared its share of GT racers, too. Chrysler charged Riley with leading its racing program for the new Viper GTS-R, campaigned it in the United SportsCar Championship and the 24 Hours of Le Mans. Auburn Hills made the unfortunate decision back in March to pull its Vipers out of Le Mans, and then in October to withdraw from the US series, as well, thereby effectively ending the program altogether. Disappointed though it surely was, Riley remains defiant. The North Carolina-based company is planning on taking the existing Vipers back to Le Mans on its own, with or without factory support. The Viper has, after all, proven a capable machine, having taken both the drivers' and teams' titles in the United SportsCar Championship this past season. "With Le Mans, every driver and every manufacturer needs to have their first trip there, and it isn't always what you want it to be, but we did show reliability and did have some pace," Bill Riley told Racer.com. "Since then, we've worked hard on the cars, they're now strong, front-running cars in the US, and we're working with the ACO on the BoP to make sure the cars are strong at Le Mans. They're super-reliable and fast, and we'd expect to be right in the mix with the other cars." Riley has kept the existing support staff in place, and once it secures its driver lineup and sponsors, chances look good that it could represent America well at Le Mans this year in either the GTE Pro or GTE Am class. Its predecessor did, after all, complete a three-year winning streak that saw it dominate the GTS class right up until its withdrawal in 2000. News Source: Racer.comImage Credit: FCA Motorsports Dodge Coupe Racing Vehicles