2013 Black Wheelchair Handicap Rear Entry! on 2040-cars

Auto blog

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

Ram to go on a Rampage with new small pickup?

When people look back at today's automotive industry, what do you think they'll remember us for? The emergence of hybrids? Ever more expensive and exotic supercars? The dawn of the self-driving car? All likely scenarios, but so is the blurring of lines between one bodystyle and another, giving rise to hardtop convertible coupes and crossovers of every shape and size. But one bodystyle the North American auto industry has stayed largely away from in the past couple of decades is a car nose and chassis with a pickup bed.
It's a bodystyle immortalized by the Chevrolet El Camino, but with few exceptions, we haven't seen too many of these automotive platypuses in recent years on our turf. Subaru tried with the Baja and the low-volume Honda Ridgeline soldiers along largely unchanged, but the genre's biggest adherents are still Down Under, where ute versions of the Holden Commodore and Ford Falcon live. With a few other examples scattered to the four corners of the earth, that's really about it. But if these spy shots are anything to go by, it looks like Fiat Chrysler Automobiles could be working to bring it back.
Spied undergoing testing in Michigan, what we appear to be looking at is a heavily disguised Fiat Strada being prepared - like the Fiat Ducato-based Ram ProMaster and the smaller Doblo-based ProMaster City - for Stateside duty as a Ram product. The Strada, for those unfamiliar, is a product of Fiat Automóveis in Brazil and is based on the Palio economy car. The nameplate has been around South America since 1996 and was originally designed by Giorgetto Giugiaro (long before Volkswagen monopolized his talents), and takes a more rugged approach in the form of the Strada Adventure.

Dodge Viper to out-Hell the Hellcat with supercharged V10?

The Viper wouldn't be the Viper if it wasn't the most powerful model under the Chrysler umbrella. But with the arrival of the Hellcat engine in the Dodge Charger and Challenger, the Viper has fallen behind in the bragging rights department: where the new supercharged V8 produces 707 horsepower and 650 pound-feet of torque, the naturally aspirated V10 offers "only" 640 hp and 600 lb-ft - gargantuan output figures by almost any other standard, but crucially behind on the SRT power scale. Conner Avenue is going to have to do something about that.
Although the Hellcat's engine reportedly won't fit under the Viper's hood, SRT is now rumored to have another trick up its sleeve: supercharge the existing V10. According to the Pentastar performance enthusiasts at allpar.com, Chrysler has already taken delivery of the first such prototype engines so that it can begin the process of fitting it into an upgraded Viper.
The spooled ten-pot is tipped to produce around 800 hp and 650 lb-ft of torque. More than that and the Viper's drivetrain, chassis and bodywork would have to be substantially reworked. Though beefier transmissions are available, fitting them would reportedly set off a domino-game of changes required to handle the added torque. Which may be something Chrysler would be prepared to do for the next-generation model, but in the meantime, 800 hp could prove enough to put the Viper back atop the Mopar performance ladder where it belongs, and give it an edge against the new Corvette Z06 to rekindle sales.