2008 Handicap Wheelchair Van Rear Entry on 2040-cars

Auto blog

FCA issues recall for 300k Dodge Chargers over airbag sensor

Fiat Chrysler Automobiles has issued another recall, this time for the Dodge Charger. The issue stems from an overly sensitive control module that could deploy the side-curtain airbag and seatbelt pretensioner if the door is kicked or slammed too hard. The recall affects certain Charger sedans from the 2011-2014 model years, specifically those manufactured between May 6, 2010, and June 5, 2014. All told, that amounts to an estimated 322,078 units, including 284,153 in the United States, another 13,169 in Canada, 2,484 in Mexico, and 22,272 overseas. Owners of those vehicles will be asked to bring their vehicles in to their local dealers to have the Occupant Restraint Control module recalibrated, and are being advised in the meantime to "exercise caution when closing doors." If this issue sounds familiar, that's because the automaker issued a similar recall for Ram trucks just last week, affecting over 667,000 four-door pickups in the United States alone. Following a further investigation into its passenger cars, FCA found a similar problem with the Charger, whose door design mandated specific calibration of the module in question for that model. The company says it is aware of three minor injuries potentially related to the issue, but no accidents. This campaign is just the latest in a string of recall-related issues to have emerged from Auburn Hills recently. The Ram truck recall was issued in tandem with another airbag-related recall for a further million pickups. Prior to that it called in another 1.4 million vehicles to update their infotainment system software due to a security issue. Another 350,000 Dodge Journeys were called in before that to have their engine covers secured. The National Highway Traffic Safety Administration is expected to issue the company a massive hundred-million-dollar fine for failing to follow proper procedures related to safety and recall issues. Meanwhile, another NHTSA investigation that could have affected 4.7 million units was closed with no further action deemed necessary. And an appeal court judge in Georgia reduced the damages the company will be ordered to pay the family of a child who died in a fire in a Jeep Grand Cherokee. Statement: Occupant Restraint Control Module August 1, 2015 , Auburn Hills, Mich. - FCA US LLC is conducting a voluntary safety recall to recalibrate control modules on approximately 284,153 U.S.-market sedans to prevent inadvertent side-curtain air-bag and seatbelt pre-tensioner deployment.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Dodge Viper saved from crusher by students, but will it last?

The saga of the Washington state community college hoping to keep its allegedly pre-production Dodge Viper out of the maw of the crusher is going strong. Not only does the school still have the car, but there's a chance that the college might even get to keep it.
The whole situation flared up in March when the South Puget Sound Community College in Olympia, WA, received a notice from Chrysler Group that requested that the school's Viper be destroyed. The automaker had loaned the muscle car to it about a decade ago to use for educational purposes in its auto tech classes. With the Dodge growing long in the tooth, "it is unlikely that these vehicles offer any educational value to students," the company said in its press release on the matter.
However, the college balked at destroying its Viper, despite the fact it had signed a contract with Chrysler Group to do so. The school further claimed that its car was incredibly special because it was a pre-production example and just the fourth one made back in 1992. Although, as we pointed out at the time, the photos of the school's vehicle showed a coupe that looked like a newer Viper GTS.