1997 Dodge Grand Caravan Wheelchair-accessible Van on 2040-cars

Auto blog

NHTSA is investigating FCA shifters for roll-away accidents again, this time the rotary units

It seems FCA's shifter troubles aren't over yet. Now, just a few months after issuing a recall to resolve user-related issues with its monostable shifters, the company is again under investigation by NHTSA. The issue is related to the potential for cars to roll away when the rotary-style shifter is not properly placed in park. Two FCA models are the subject of this investigation: the 2013–2016 Ram 1500 and the 2014–2016 Dodge Durango. NHTSA estimates about 1,000,000 vehicles would be affected if a recall is issued. The investigation was started following 43 complaints of vehicles rolling away while supposedly being in "park." Among the complaints were reports of 25 crashes and 9 injuries. NHTSA does point out that in every incident, the parking brake was not engaged. A representative from FCA also gave us an official statement regarding the investigation: "FCA US is cooperating fully with NHTSA's investigation, the scope of which is limited. Other vehicles equipped with rotary shifters are not included. In accordance with prudent practice, the Company joins NHTSA in urging all drivers to use their vehicles' parking brakes." View 35 Photos As mentioned above, other Chrysler products with rotary shifters, such as the Pacifica minivan and 200 sedan, are not involved in this investigation. One of the key differences, as the representative told us, is that these vehicles have electronic parking brakes that automatically engage if the driver does not select park and then opens the door with the seatbelt unbuckled. The Ram 1500 and Durango feature mechanical, manually operated parking brakes and therefore cannot activate the brake automatically. Because this is currently an investigation, an exact cause for the incidents has yet to be determined, and none of the vehicles have been recalled. It's possible there could be a mechanical defect. However, the issue could be a confusing interface causing user error, as was the case with FCA's monostable shifters, where drivers think they've put the car in park but actually haven't. Something that indicates it could be a case of confused users is that NHTSA also opened an investigation into 2012–2014 Jaguar XF and Land Rover Range Rover Evoques for similar issues. Both vehicles use a rotary shifter and have had roll-away complaints levied as well. Even if it is a case of user error, FCA and Jaguar Land Rover may still have to recall their vehicles.

Dodge Hornet supposedly snapped inside Alfa Romeo Tonale factory

It appears that someone in Stellantis' Pomigliano d’Arco Assembly Plant in Italy couldn't keep their cellphone to themselves. Video uploaded to the Alfa Romeo Club Italia Facebook page, then quickly removed, purports to show Dodge's brand-engineered version of the Alfa Romeo Tonale in the same factory where the Alfa will be built. The Dodge is expected to be called the Hornet, and there are a few differences between it and and Alfa Romeo, which is understandable. But if the screenshots on Twitter are accurate, then the Dodge looks a lot closer to the Alfa Romeo than perhaps anyone expected. The front fascia and hood fall in line with Dodge's design language. The Alfa grille is replaced by a narrow, stepped upper grille, and the hood is one of the vented units similar to those available for Dodge's R/T performance trims. And as Mopar Insiders noticed, the silhouette of this car's front end matches a vehicle silhouette Dodge showed during Stellantis' 2021 EV Day.   Inside, the Italian brand's crest in the steering wheel center cap is replaced by Dodge's twin slashes, and the steering wheel has been stripped of the large, curved paddle shifters the Tonale showed on its debut. There's still a start/stop button on the steering wheel, but where the Tonale has a driving mode dial on its dash, this supposed Hornet has another start/stop button. Dodge's push-to-start buttons are usually on the instrument panel, so our guess is that the wheel is a holdover for testing. On the center tunnel, the parking alert buttons and Italian Tricolore flag on the Alfa Romeo are replaced by three different buttons.   We've known Dodge has two electrified vehicles on the way, and the Hornet name has been low-key buzzing for two years. Fiat Chrysler applied to trademark the name in the U.S. in March 2020; at the time, it was thought a vehicle with that name could replace the Journey. In 2021, a July rumor out of Italy was the first whisper of the Hornet name being attached to the Alfa Romeo Tonale. In August, when Stellantis CEO Carlos Tavares said Dodge would get a PHEV in 2024, watchers pegged that model as the Hornet. That hybrid powertrain would show a year after the vehicle's launch, the Hornet anticipated as a 2023 model with the Tonale's turbocharged 2.0-liter four-cylinder. That engine could get the same 256 horsepower and 295 pound-feet of torque as the Tonale, or be boosted to satisfy Dodge's performance credentials.

Chrysler to accelerate production of 2013 Ram and V6 engines

Chrysler is adding a third shift at its Warren Truck plant to meet demand for the new 2013 Ram pickup. And with tight supplies of its Pentastar V6, the company is also boosting output at its Mack Engine plant.
The expansions will add 1,250 jobs and are part of a $238 million investment by Chrysler in the Detroit area. Warren's third shift will begin work sometime in the spring, a Chrysler rep told Automotive News. Mack's increased Pentastar production a could include both 3.6 and 3.2-liter engines.
The company says it also plans to invest $40 million in its Trenton Engine plant to allow for production of a 3.2-liter V6 as well as the Tigershark inline-four for the upcoming Jeep Liberty replacement.