2008 Dodge Avenger Se Sedan 4-door 2.4l on 2040-cars

Auto blog

Dodge Charger to slim down and run turbo four in next generation

The current Dodge Charger is getting long in the tooth. It was originally introduced in 2005 as a 2006 model. In car terms, that's an eternity, though it's been refreshed twice. Still, FCA US will keep the LX-generation car going, reportedly facelifting it one last time for 2019. After that, there are some bigger changes in store . Automotive News is reporting that the follower to the current LX Charger will lose almost 500 pounds and will once again offer a turbo four-cylinder. You might remember the front-wheel-drive four-banger Charger of the early '80s. The recharged sedan will be twin-turbo and it's going to use the 300-horsepower four-cylinder engine currently under development for the 2018 Jeep Wrangler, AN says. The target weight for the future car is around 3,500 lbs, while the current car has a curb weight of nearly 4,000 lbs. Look for it to arrive in the early 2020s. The new platform will have a touch of Italian flair instead of the Daimler-Benz flavor embedded deep inside the LX cars. It will be built on an extended version of the 2017 Alfa Romeo Giulia's "Giorgio" platform, according to AN. Dealers were already shown a styling-buck almost a year ago. Related News: Featured Gallery 2015 Dodge Charger R/T View 42 Photos News Source: Automotive NewsImage Credit: AOL Alfa Romeo Dodge Future Vehicles Sedan FCA

Watch a Dodge Viper driver show off his V10 all the way into a wall

Has there ever been a show-off video that doesn't end terribly? This video clip captured with a cellphone shows the driver of a neon green Viper GTS giving a fellow motorist a couple throttle blips to signify his intent – which seems to be to crash the Viper into a concrete wall as quickly as possible. It's not pretty. The mean machine seems to be a second-generation Viper GTS in Stryker Green. To our knowledge, no photos have surfaced of the aftermath, so we wish both the driver and their most-likely bruised ego a speedy recovery. Who knows, maybe the Viper is also salvageable.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.